A full featured desktop or wall mount corded telephone (no microwaves) combined with a special ultra low EMF headset. You get all the benefits of a normal telephone without putting yourself close to the strong magnetic fields associated with the handset, speakerphone, or phone base. The special headset cord is about 3 feet long and uses a plastic tube to carry the sound to your ear. Absolutely no electronics, wires or magnets are near your ear. Cord provides distance from telephone base and traditional handset, convenient mobility, and can be extended up to 15 feet with option extension cord, sold separately (see below). Tested and approved by Less EMF Inc., dramatic field reduction when the headset is used. Although pictured as white, our current stock is a black phone.
Says Dr. Carlo: “We also conducted four different epidemiological studies on groups of people who used cell phones, and we did clinical intervention studies. For example, studies of people with implanted cardiac pacemakers were instrumental in our making recommendations to prevent interference between cell phones and pacemakers. In all, we conducted more than fifty studies that were peer-reviewed and published in a number of medical and scientific journals.”
It also means regulators need to make sure their policies reflect new levels of exposure. The Federal Communications Commission currently oversees cellphone safety and sets the limits for how much radiation people should be exposed to. (This is measured by the specific absorption rate — the rate at which the body absorbs radio frequency energy — and the current limit for cellphones is 1.6 watts of energy per kilogram of tissue. The whole-body threshold is a SAR value of 0.08 watts per kilogram, and the tower radiation limit is 10 watts per square meter.)
We did not simply measure energy coming from the front of the case which is the area of the case where the phone would be "shielded" from radiation. If we had taken readings with a directional meter, specifically measuring energy coming from only the front or flap cover where the shielding material is, we assume as the manufacturers claim, that we would have seen a drop in the radiation readings.
Specific Absorption Rate (SAR) is an indicator for calculating the level of radiation absorbed in the body. This indicator represents the rate of energy absorption by the tissue and is expressed in units of Watt/kg. The Consumer Protection Regulations (information on non-ionizing radiation from mobile phones) of 2002, stipulate the duty to label the product, specifying the radiation level of the phone’s model and the maximum permitted radiation level. This regulation allows to compare the emitted radiation level between different instruments and to take this into consideration when weighing the factors determining the choice of a new instrument at the time of its purchase.
Pong’s research indicates that badly designed cell phone cases can partially block a phone’s antenna, making the device work harder to transmit signals. Due to gaps in the FCC’s cell phone regulations, a phone worn right next to the body and enclosed by a case that obstructs the antenna could expose the user to more radiation than the FCC’s legal limit.
Some people might consider choosing a phone with a low SAR value. Different models of phones can give off different levels of RF waves. But as noted above, according to the FCC the SAR value is not always a good indicator of a person’s exposure to RF waves during normal cell phone use. One way to get information on the SAR level for a specific phone model is to visit the phone maker’s website. The FCC has links to some of these sites here: www.fcc.gov/encyclopedia/specific-absorption-rate-sar-cellular-telephones. If you know the FCC identification (ID) number for a phone model (which can often be found somewhere on the phone or in the user manual), you can also go to the following web address: www.fcc.gov/oet/ea/fccid. On this page, you will see instructions for entering the FCC ID number.
Leibovich was very careful to point out in our interview that Cellsafe is not claiming that the radiation absorbed by the body during phone use leads to health issues like brain tumours, male infertility or damage to unborn babies. But the Cellsafe website strongly suggests these links. Its homepage (image below) leads with the phrase "You should be concerned!" in an eye-catching red, and there is as much screen real estate on the site dedicated to information about the dangers of radiation, as there is for descriptions of the Cellsafe products. This information refers to "high levels of RF radiation" in several places, but it doesn't say whether this describes radiation from phone use.
The only sure way is to stop using a cell phone. Most people however would prefer to play safe by simply reducing their exposure to radio frequency radiation. Bluetooth devices emit only 10% of the radiation of a cell phone. A hands-free set enables the user to keep the phone away from the head but usually leaves the phone near some other part of the body. It is safe to say that in the event that radio frequency radiation causes damage, you would like to protect other parts of your body. Therefore the only way to reduce your risk is to reduce the radio frequency radiation your body absorbs. SAR Shield reduces radio frequency radiation by up to 89%.