EWG believes that cell phone testing procedures should include cases and other accessories, whether supplied by the phone manufacturer or a third party. Since these cases and accessories have no other use and have the potential to influence the phone’s transmitting and receiving activity and the amount of radiation that a user might encounter, they fall within FCC’s authority.


Searching PubMed for studies published in the past 10 years, we found 102 studies that ultimately resulted in 12 relevant systematic reviews. To limit bias in our assessment of the literature, we used a validated critical appraisal tool called AMSTAR to determine the quality of each review. Eight of the reviews were critically low quality, two were low quality, and two were moderate quality.
Forced to take action, the cell phone industry set up a non-profit organization, Wireless Technology Research (WTR), to perform the study. Dr. Carlo developed the program outline and was asked to head the research. Oversight of the issue was charged to the FDA, though it could have and probably should have gone to the Environmental Protection Agency (EPA), which fought hard for jurisdiction. But the industry had enough influence in Washington to get whatever overseer it wanted. It simply didn’t want to tangle with EPA because, says Dr. Carlo, “… the EPA is tough.”
The most common effect is heat generation (though non-thermal biological harm has also been demonstrated), which can alter the characteristics of various bodily tissues depending on the amount of radiation present and its ability to penetrate the body. Tissue damage can promote the cellular mutations and increase your long-term risk of developing cancer.
Pong’s claims for its case have stood up to the scrutiny of Wired magazine and the Better Business Bureau (Advertising Self-Regulation Council 2012; Ganapati 2009). In tests conducted by Cetecom, a cell phone radiation certification lab, and observed by a reporter from Wired magazine, an iPhone 3G tested without a case had a maximum SAR of 1.18 W/kg when held at the ear. The same phone tested with a Pong case had a maximum SAR of 0.42 W/kg (Ganapati 2009).  
I love this case. However, I don't understand what happens to the radiation that must collect under the case; isn't there a burst of radiation when the case is opened? I posted this question but the answers were from people who hadn't thought of that issue; they didn't have the answer, except for one who theorized that the radiation is slowly leaking out the top, bottom, and sides. I assume the case keeps radiation off the hand that holds the case with the phone in it, which is great, but I do wonder about the stored radiation when, for example, I'm listening to a podcast with the case closed, then open it later.
Specific Absorption Rate is an indicator of how much EMF radiation body tissue absorbs when you’re using a cell phone and is one way to measure and compare the harm of different devices. In this article, I wanted to provide a resource to compare and contrast the SAR levels of many popular phones and talk a bit about what Specific Absorption Rate is, and how we can use it.
Several studies that will provide more information are under way. Researchers from the Centre for Research in Environmental Epidemiology in Spain are conducting another international case–control study—Mobi-Kids—that will include 2000 young people (aged 10–24 years) with newly diagnosed brain tumors and 4000 healthy young people. The goal of the study is to learn more about risk factors for childhood brain tumors.
Since use of mobile phones by children began at a later stage compared to use by adults, the effects of exposure to mobile phones in this population have not yet been investigated. Considering their health sensitivity, the long life expectancy in the young population (probably involving the accumulation of significant exposure and development of morbidity in the long-run), and ethical issues involved in decision making regarding the population of minors, additional precaution is required in this population. Therefore, the Ministry of Health advises parents to reduce children’s exposure to mobile phones as much as possible, consider the age they start using them, reduce the amount of time mobile phones are used, and in any event, make sure they use earphones (not wireless) or a speaker when using the mobile phone.

Remember: The cancer incidence data in humans, at least to date, suggests no avalanche of head and neck tumors. Since so many people are exposed to cellphones, if there were a big risk, we’d probably see it turn up. “If cellphones caused brain tumors at the rate that cigarettes caused lung cancer,” said Otis Brawley of the American Cancer Society, “we would have figured it out by now.”
Take a closer look at the product claims. Many refer to their “shielding technology” and not the product itself. In many cases, the “FCC Certified” labs they cite are actually testing how much RF the raw shielding material can block. They’re testing the materials used in the products. They’re not testing how much RF the actual products block while on a real-world phone.
Read the “fine print” from the manufacturer’s instruction manual which tells users to put a distance between the phone and your head and body. These fine print warnings range  from a few millimeters to almost an inch. The fine print warnings on other wireless devices (such as Wi-Fi routers, wireless printers, home cordless phone base stations and baby monitors) generally state the distance should be at least 20 cm, or about 8 inches. If people are closer than the manufacturer stated separation distance, then they can be exposed to RF levels that violate the US government FCC limits for this radiation.
The magnet is not nearly as strong as it should be. If the higher priced value is based on antiradiation technology - with quality control testing - how could they not install a magnet that is strong enough to withstand a drop or at least a smaller magnet on the cardholder side? You have to put the magnet flap in-between the back/front which is very annoying...and we all know the leather is not from Florence.
In 2011, two small studies were published that examined brain glucose metabolism in people after they had used cell phones. The results were inconsistent; whereas one study showed increased glucose metabolism in the region of the brain close to the antenna compared with tissues on the opposite side of the brain (26), the other study (27) found reduced glucose metabolism on the side of the brain where the phone was used.
Cell-phone designs have changed a lot since the studies described above were completed. For example, the antennas—where most of the radiation from cell phones is emitted—are no longer located outside of phones near the top, closest to your brain when you talk, but are inside the phone, and they can be toward the bottom. As a result, the antenna may not be held against your head when you’re on the phone. That’s important because when it comes to cell-phone radiation, every milli­meter counts: The strength of exposure drops dramatically as the distance from your body increases.
“The evidence so far doesn’t prove that cell phones cause cancer, and we definitely need more and better research,” says Michael Hansen, Ph.D., a senior scientist at Consumer Reports. “But we feel that the research does raise enough questions that taking some common-sense precautions when using your cell phone can make sense.” Specifically, CR recommends these steps:
Don’t be mislead by a common misconception started in the 90′s that wired headsets, that the headset that came with your cell phone is a safe alternative to placing a phone to your head.   This is simply not true at all! Ordinary headsets use a wire to deliver sound to an electronic earpiece that can deliver electromagnetic radiation into your head directly through your ear canal.
In this frequency range, the interaction between matter and light is via the electric field component of light (totally different from how ionizing radiation messes you up). In particular, an oscillating electric field causes polar molecules to rotate or attempt to rotate, and the lag between the applied field and the response of the molecules manifests as dissipation—i.e. heating [3]. This is the same dielectric heating which is the operating principle behind microwave ovens (which operate at 2450 MHz [4] similar to wifi). So if cell phones were to cause damage to tissue, the mechanism would be the same as what happens in a microwave oven—boiling the water in your head/body.
Specific Absorption Rate is an indicator of how much EMF radiation body tissue absorbs when you’re using a cell phone and is one way to measure and compare the harm of different devices. In this article, I wanted to provide a resource to compare and contrast the SAR levels of many popular phones and talk a bit about what Specific Absorption Rate is, and how we can use it.
Note: Although it is true that cell phones emit low frequency magnetic fields that can be measured in milliGauss, they also emit high frequency microwave radiation which is what all the concern (and publicity) is about, and which the products below are designed to shield. Many clients have contacted us seeking a shield for BOTH magnetic fields and microwaves for their phone. Such a shield does not currently exist. To reduce your exposure to BOTH types of radiation, use an airtube headset and keep the phone itself at a distance.
A third requirement was for the FDA to create a formal interagency working group to oversee the work and provide input. The purpose of this was to alleviate any perception that the industry was paying for a result, not for the research itself. But the fourth and last requirement was considered by Dr. Carlo to be highly critical: “Everything needed to be done in sunlight. The media had to have access to everything we did.”
"For example," Johnson said, "what does a fractal like pattern have to do with a hologram? The answer is, of course, nothing that is apparent. Then there is a truly convoluted assertion that cell phones can be instrumental in ‘psychoemotional' effects on humans because of their lower-frequency outputs. This too, is gibberish. In short, this is technobabble that will potentially snow someone who has no science background."
Yes, the information transferred between the base unit (the phone’s stationary unit) and the wireless phone’s mobile unit is transferred as radiowave radiation. Therefore, the “precautionary principle” should also be adopted regarding wireless phones. In addition to the guidelines regarding mobile phones, the Ministry of Health recommends regarding wireless phones:

No special wiring or installation is required. Phone includes volume control, speed dial, redial, speakerphone and hold features. Now with caller ID feature as well! Does NOT have answering machine. Phone can also be used in normal fashion by those not affected by EMF. Color is black, phone color and styles may vary. The phone itself does not have any special shielding nor EMF reduction technology. The whole benefit is that it has the jack for the special air tube headset.

There are ongoing worries about whether cellphones can give you cancer — especially brain cancer, since our phones spend so much time near our faces. It’s true that cell phones do emit radiation. But it’s radiofrequency radiation, which is much lower energy than the ionizing radiation you’d get from an X-ray, or, say, nuclear fallout. Ionizing radiation can cause DNA damage that can eventually lead to cancer. But the radiofrequency radiation from a cellphone doesn’t work that way — and today’s results support that.


For those of you who experience (or want to prevent) ES symptoms in your hands when using a computer keyboard, laptop, cell phone or other electronic devices, these gloves form a conductive enclosure and effectively shield radiowaves and electric fields. Soft, light weight, with ribbed cuff, and offering good tactile sensitivity. Polyester fiber is twisted with pure Silver fibers, then knit into a stretchy glove shape in basic gray color. Each glove has a 1.7 mm snap for a ground cord. Fully hand washable and tested for 50 cycles with no appreciable loss of conductivity. All fibers are conductive, achieving resistivity of less than 10 Ohm/sq. These gloves are also used in industry for static control when working with delicate static sensitive components and can even be used for TENS applications. Grounding is not necessary for Faraday Cage shielding effect, but is necessary for static control. Also useful on touch screens like an iGlove. We do not have the ground cord which fits this snap on these gloves. Shielded Gloves:

Prime free trial and invitee customers: We will automatically apply an Amazon.com Gift Card to your Gift Card Balance in the amount equal to the Prime exclusive discount after you become a paid Prime member. If you cancel your paid Prime membership or return the qualifying smartphone within the first 3 months of your paid Prime membership, we may void your Gift Card or charge you in the amount of the Gift Card. Terms and Conditions apply.
EWG also reviewed data in the FCC filings on tests of battery life during a continuous call, measured on an iPhone 4 without a case and on the same phone with an Incipio Le Deux case. This case was chosen because it contains metallic parts (a stainless steel back plate). The presence of metallic components influences the phone’s radiation properties, as the FCC acknowledges (FCC 2001; FCC 2014). Under the test conditions with constant signal strength, an iPhone 4 without a case had 85 percent of battery capacity after a one-hour call and 70 percent after two hours. When the test was repeated with the Incipio Le Deux case, the phone had only 65 percent of battery capacity after a one-hour call and only 10 percent after two hours (Pong 2012).
INTEGRITY: Many manufactures claim near 100% EMF protection, referring to the radiation blocking material, NOT the protection you receive on a call. If you covered your whole phone with EMF blocking material, then you'd have no signal. Our EMF blocking material is used on the front cover only, providing you real EMF protection with no sacrifice in reception.
While talking on your cell phone, prefer to position the cell phone away from your body as far as possible. Whenever possible, use the speakerphone mode or an airtube wired headset (not a wireless headset, not a wireless earpiece). The electromagnetic field (radiation) is one-fourth the strength at a distance of two inches and fifty times lower at three feet.
3. A lab setting is the only legitimate way to show the effectiveness of our technology for a few main reasons: one, a controlled source is the only way to conduct a scientific study. Note that the controlled source that we used was specifically designed to simulate emissions from wireless electronics (RF and ELF emissions of various frequencies). Two, ambient levels in a non-controlled environment will affect readings, rendering the results inaccurate. Three, at-home equipment such as the meter used in the video is not suitable for the types of emissions by a wireless device, nor are they reliable.
Exposure to ionizing radiation, such as from x-rays, is known to increase the risk of cancer. However, although many studies have examined the potential health effects of non-ionizing radiation from radar, microwave ovens, cell phones, and other sources, there is currently no consistent evidence that non-ionizing radiation increases cancer risk in humans (2).
×