For example, cellphone manufacturers currently test these devices for compliance with FCC standards by placing them against the head, and near the torso with some separation. Just check out Apple’s iPhone manual: The company tests the specific absorption rate at a 5mm separation from the body. But if you wear your device in your pocket, you’re probably not going to have that 5mm separation, meaning you may be exposed to more radiation — perhaps enough to exceed current standards.
A recent large study by the US National Toxicology Program (NTP) exposed large groups of lab rats and mice to RF energy over their entire bodies for about 9 hours a day, starting before birth and continuing for up to 2 years (which is the equivalent of about 70 years for humans, according to NTP scientists). The study found an increased risk of tumors called malignant schwannomas of the heart in male rats exposed to RF radiation, as well as possible increased risks of certain types of tumors in the brain and adrenal glands. But some aspects of this study make it hard to know just how well these results might be applied to cell phone use in people. For example, there was no clear increased risk among female rats or among male or female mice in the study. The doses of RF radiation in the study were also generally higher than those used in cell phones (ranging from 1.5 W/kg to 6 W/kg in rats, and 2.5 W/kg to 10 W/kg in mice), the animals’ entire bodies were exposed, and the amount of time they were exposed was longer than most people typically spend on the phone each day. The male rats in the study exposed to RF waves also lived longer, on average, than the rats who were not exposed, for unclear reasons. Because of this, the NTP has noted that the study results cannot be directly applied to humans. Still, the results add to the evidence that cell phone signals might potentially impact human health.

Cables can act as an antenna, especially if they pass close to a strong source of radiofrequency radiation. One study has suggested that if the cable of a hands free mic passes near the phone's antenna, it can pick up some radiation and transmit it to your ear. Our ferrite snap bead is designed to reduce RF radiation in the cable. Made in 2 halves, you simply press it around the hands free wire at any convenient location near the earpiece end. Couldn't be simpler. It is small and lightweight enough to be almost unnoticable, yet powerful enough (50 ohm impedence minimum) to control nasty radiation. These are brand new, top quality and will accommodate wires up to 5 mm (3/16 inch) in diameter. About 1 inch long, grey color. If you are concerned about radiation from your hands free ear mic, this is the answer. Useful from 200-1000 MHz.
If you want to measure the EMF radiation from your own phone, and know if EMF protection products are working, you should get a quality EMF meter. I highly recommend the new TriField TF2 (read my review) as it’s simple to use, lasts forever, is extremely accurate, and measures all three types of EMF radiation. If you’re looking for a low-cost EMF meter I really like the Meterk (read my review).

✅ THE EMF PROTECTION CELL PHONE RADIATION SHIELD IS HERE: All 4-10 Personal Quantum Schumann Frequency Generator. Universal Quantum Resonates with users energy field increases and maintains high energy field. Use directly on any mobile phones and 7’’ tablets or carry it in the wallet, on the body, bag. Our stylish radiation reducing shield will decimate the amount of radiation you are being exposed to every minute of every day –the same radiation that WHO has listed as a class 2B Carcinogen!
Exposure to ionizing radiation, such as from x-rays, is known to increase the risk of cancer. However, although many studies have examined the potential health effects of non-ionizing radiation from radar, microwave ovens, cell phones, and other sources, there is currently no consistent evidence that non-ionizing radiation increases cancer risk in humans (2).
×