We tested the garments in a similar setup with the fabric between the phone and the meters. We also tested the garments while sitting on a couch, holding the Gigahertz Solutions monitor against my pregnant belly under the product (blanket/nursing cover) and measuring the reduction of the RF from my cellphone in my hand at normal texting/web-surfing distance.
SafeSleeve's report is right up front about showing that they do not test or certify the Safe Sleeve case, rather they are simply testing the material they put into the case in a completely artificial environment, in a laboratory setting, using a signal generator and a power amplifier. Safe Sleeve includes photos showing how the measurements are taken. But that may not be how anyone will ever use their phone.
If you're looking for ways to limit your exposure to the electromagnetic emissions from your cell phone, know that, according to the FTC, there is no scientific proof that so-called shields significantly reduce exposure from these electromagnetic emissions. In fact, products that block only the earpiece – or another small portion of the phone – are totally ineffective because the entire phone emits electromagnetic waves. What's more, these shields may interfere with the phone's signal, cause it to draw even more power to communicate with the base station, and possibly emit more radiation.
These expert committees determined that there are indeed gaps in the knowledge concerning the implications of exposure to this radiation, and therefore they called for further studies on the subjects and recommended to adopt the “precautionary principle". This principle adopts simple and relatively cheap means to reduce exposure to the minimum radiation levels possible with existing technology.
ShieldMe On the ShieldMe site is a message from Wireless Connection CEO Rose Vitale addressing issues with the cellphone industry and she makes some good points. As far as how ShieldMe works she states, " Our ShieldMe cases help deflect up to 99% of the harmful EMF, RF or microwave radiation emitted from a cellphone while carrying around or when on a call." The demonstration of the SheildMe case shows levels that like the "EMF protection cellphone cases" is many many times higher than levels EMF expert Larry Gust follows as a certified building biologist.
The exact source of radiation in a cell phone is from the transmitter, a device located near the antenna that converts audio data into electromagnetic waves. The amount of radiation a cell phone can emit is limited by legal restrictions in the U.S., Canada and Europe. Additionally, the average radiation levels of most mobile phones are available to the public, courtesy of the Federal Communications Commission in the U.S.
Some products (http://www.safecell.net/reports01.html for example) are tested using a piece of shielding material in a laboratory test jig. These tests legitimately show the amount of radiation which penetrates the shield, but results will be very different when compared to putting a small amount of the same shield on a large transmitter like a cellphone. Remember, the entire phone radiates. Placing a small amount of shielding, even if it is an effective shielding material, only shields that small area at best. Think about this analogy: no light will penetrate a penny as it is a very effective light shield, but it is silly to think that holding a penny up to the sun will put you in darkness.
The next day, telecommunications stocks took a big hit on Wall Street and the media had a field day. The industry trade association at the time, the Telecommunications Industry Association (TIA), went into crisis mode, claiming thousands of studies proved cell phones were safe and what Reynard and his attorney said was bunk. TIA reassured the public that the government had approved cell phones, so that meant they were safe. The media demanded to see the studies, but, says Dr. Carlo, “The industry had lied. The only studies in existence then were on microwave ovens. At that time, 15 million people were using cell phones, a product that had never been tested for safety.”
In a February 2 statement, Jeffrey Shuren, director of the FDA’s Center for Devices and Radiological Health, wrote that despite the NTP study’s results, the combined evidence on RF exposure and human cancer—which by now amounts to hundreds of studies—has “given us confidence that the current safety limits for cell phone radiation remain acceptable for protecting the public health.” Chonock says that for him, evidence from the Ramazzini study does not alter that conclusion. “We continue to agree with the FDA statement,” he says.
But there is also some ambiguity about cellphone radiation’s health effects. As Dr. John Bucher, a senior scientist at the National Institute of Environmental Health Sciences and a co-author of the NIH studies, told me, “[Our results] go against the notion that non-ionizing radiation is completely harmless.” In other words, he’s found that the type of radiation cellphones give off could cause biological changes, like promoting tumors, at least in animals.
There are alternate technologies that can be considered when looking to reduce cell phone radiation exposure which we don’t use. Why don’t we use them? Incorporating technologies such as antennas into a case can greatly reduce outgoing cell phone radiation levels when close to the cell tower, but not totally. If farther away, the cell phone signal levels increase, as does the radiation exposure to the body, possibly to unacceptable output power levels. This design does not reduce radiation exposure from the WiFi and Bluetooth RF because cell phones do not have the capacity to reduce their power levels whether or not an antenna is present. Maybe just as important, this design does not have the shielding capacity for ELF emissions which have the same dangers as the RF emissions. Other device attachments like buttons and stickers are minimally effective to totally ineffective, with no scientific basis. In short, there are no other technologies capable of up to eliminating all of the many potentially harmful cell phone emissions from hitting the body.
While the Federal Communication Commission limits how much radiofrequency radiation can come out of your cellphone, the Food and Drug Administration can have a say about whether those limits are safe. So the FDA asked the National Toxicology Program (NTP), a division within the National Institutes of Health, to investigate. Based on the NTP’s results, as well as hundreds of other studies, the FDA is still confident that the current limits on cellphone radiation are safe, according to a statement from Jeffrey Shuren, the director of the FDA’s Center for Devices and Radiological Health.
If you are not 100% satisfied with any purchase made directly from Life Extension®, just return your purchase within 12 months of original purchase date and we will either replace the product for you, credit your original payment method or credit your Life Extension account for the full amount of the original purchase price (less shipping and handling).
Specific Absorption Rate is an indicator of how much EMF radiation body tissue absorbs when you’re using a cell phone and is one way to measure and compare the harm of different devices. In this article, I wanted to provide a resource to compare and contrast the SAR levels of many popular phones and talk a bit about what Specific Absorption Rate is, and how we can use it.
The average radiation level of a Bluetooth earpiece is 0.23 watts per kilogram (W/Kg) according to RF Safe. This is 10 to 100 times higher than the amount of radio frequency (RF) exposure needed to create “leaks” in the blood-brain barrier, allowing for toxins (not to mention the radiation itself!) to pass through into the brain. It’s best to just say NO to Bluetooth!
EWG also reviewed data in the FCC filings on tests of battery life during a continuous call, measured on an iPhone 4 without a case and on the same phone with an Incipio Le Deux case. This case was chosen because it contains metallic parts (a stainless steel back plate). The presence of metallic components influences the phone’s radiation properties, as the FCC acknowledges (FCC 2001; FCC 2014). Under the test conditions with constant signal strength, an iPhone 4 without a case had 85 percent of battery capacity after a one-hour call and 70 percent after two hours. When the test was repeated with the Incipio Le Deux case, the phone had only 65 percent of battery capacity after a one-hour call and only 10 percent after two hours (Pong 2012).
An analysis of data from NCI's Surveillance, Epidemiology, and End Results (SEER) Program evaluated trends in cancer incidence in the United States. This analysis found no increase in the incidence of brain or other central nervous system cancers between 1992 and 2006, despite the dramatic increase in cell phone use in this country during that time (22).