I love this case. However, I don't understand what happens to the radiation that must collect under the case; isn't there a burst of radiation when the case is opened? I posted this question but the answers were from people who hadn't thought of that issue; they didn't have the answer, except for one who theorized that the radiation is slowly leaking out the top, bottom, and sides. I assume the case keeps radiation off the hand that holds the case with the phone in it, which is great, but I do wonder about the stored radiation when, for example, I'm listening to a podcast with the case closed, then open it later.
Designed to be “leaky”, it permits only a fraction of the RF radiation to penetrate. Exposure to people is reduced (typically 90-99% reduction), and the device usually still works, but with a more limited range. Great for when you permanently or temporarily want to quiet microwave levels without fully turning off the source. Place it over cellphones, cordless phones, two-way radios, smart devices, even wifi routers. Sturdy metal. The two larger units have convenient handle and access holes for wire and cable pass through. Pick the sizes which meet your needs.
There are alternate technologies that can be considered when looking to reduce cell phone radiation exposure which we don’t use. Why don’t we use them? Incorporating technologies such as antennas into a case can greatly reduce outgoing cell phone radiation levels when close to the cell tower, but not totally. If farther away, the cell phone signal levels increase, as does the radiation exposure to the body, possibly to unacceptable output power levels. This design does not reduce radiation exposure from the WiFi and Bluetooth RF because cell phones do not have the capacity to reduce their power levels whether or not an antenna is present. Maybe just as important, this design does not have the shielding capacity for ELF emissions which have the same dangers as the RF emissions. Other device attachments like buttons and stickers are minimally effective to totally ineffective, with no scientific basis. In short, there are no other technologies capable of up to eliminating all of the many potentially harmful cell phone emissions from hitting the body.
The frequency of radiofrequency electromagnetic radiation ranges from 30 kilohertz (30 kHz, or 30,000 Hz) to 300 gigahertz (300 GHz, or 300 billion Hz). Electromagnetic fields in the radiofrequency range are used for telecommunications applications, including cell phones, televisions, and radio transmissions. The human body absorbs energy from devices that emit radiofrequency electromagnetic radiation. The dose of the absorbed energy is estimated using a measure called the specific absorption rate (SAR), which is expressed in watts per kilogram of body weight.
×