There is some concern that my iphone was working even when turned off, as it would somehow use the battery over the coarse of a few months of being turned off. So long as it isn’t government mandated that we not interfere with their ability to find our phone when they want, I want to make sure they can’t. Yes they can argue only a terrorist would want that. But I’m no terrorist and I want that because like millions of Americans, I dislike the idea of Big Brother constantly keeping digital tabs on me.
“If you’re looking for ways to limit your exposure to the electromagnetic emissions from your cell phone, know that, according to the FTC, there is no scientific proof that so-called shields significantly reduce exposure from these electromagnetic emissions. In fact, products that block only the earpiece – or another small portion of the phone – are totally ineffective because the entire phone emits electromagnetic waves. What’s more, these shields may interfere with the phone’s signal, cause it to draw even more power to communicate with the base station, and possibly emit more radiation.”

Fears that the low-energy radiation emitted by cellphones could cause cancer seem to have been simmering ever since cellphones went mainstream. The latest flare up is probably thanks to two things: an article in The Nation about “Big Wireless” and a government study that recently reported some male rats exposed to huge doses of full-body cellphone radiation developed a rare type of heart tumor.

To check for radiowave emissions, use an RF meter with Near Field antenna. Again, position the antenna loop on the phone (because the entire antenna stem has some sensitivity, it is best to position the entire antenna over the area that will be shielded). Note carefully where the loop is positioned. Make a call and watch the readings. Notice the highest and lowest readings, and make a mental note of the "average" reading. Now, insert the shield, and repeat.
Don’t rely on a “radiation shield” or other products claiming to block RF energy, electromagnetic fields, or radiation from cell phones. According to the U.S. Federal Trade Commission, products that interfere with the phone’s signal may force it to work harder and emit more RF energy in order to stay connected, possibly increasing your exposure. It is best to use wired solutions to reduce RF rather than rely on an untested  product.

†Results may vary. Information and statements made are for education purposes and are not intended to replace the advice of your doctor. Global Healing Center does not dispense medical advice, prescribe, or diagnose illness. The views and nutritional advice expressed by Global Healing Center are not intended to be a substitute for conventional medical service. If you have a severe medical condition or health concern, see your physician.


Once the surface is completely dry, the surface will have a visible residue remaining on the glass. Take the same microfiber and remove the residue by rubbing the surface until it is shiny and smear free. Do not use any other alcohol or cleaning agent on the glass and apply a new layer of the Ti22 Liquid Titanium Shield every 6-12 months depending on how heavy you use the phone or tablet.


Let’s be honest, we’re addicted to our smartphones. According to an ABC news report, the average person checks their phone 150 times per day, not to mention the other 15 hours per day it sits in your pocket. It’s also nothing new that cell phones emit Electromagnetic Fields/Radiation (EMF/EMR) when it’s glued to the side of our head more than 22 times per day. 

Dr Davis holds a B.S. in physiological psychology and an M.A. in sociology from the University of Pittsburgh, 1967. She completed a PhD in science studies at the University of Chicago as a Danforth Foundation Graduate Fellow, 1972 and a M.P.H. in epidemiology at the Johns Hopkins University as a Senior National Cancer Institute Post-­Doctoral Fellow, 1982. She has authored more than 200 publications and has been published in Lancet and Journal of the American Medical Association as well as the Scientific American and the New York Times.
This is the second Cell Shield protector I have purchased. I have had one for my cell phone for almost a year now and it has been wonderful! When my husband upgraded to a new phone, I knew I needed to purchase one for him. The application of the button is very simple and it stays on well. Due to the fact that it is a 'raised' button (a few millimeters thick), some may find it difficult to know where to apply it. I have an i4 phone with an Otterbox case. There is a round cut-out hole in the case that lines up with the 'apple' symbol on the back of the phone. I was able to place the button in that cut-out and it lines up flush with the cover. I highly recommend this Protector to anyone looking to significantly and effectively block EMF's.
In order to protect the population living around base stations and users of mobile handsets, governments and regulatory bodies adopt safety standards, which translate to limits on exposure levels below a certain value. There are many proposed national and international standards, but that of the International Commission on Non-Ionizing Radiation Protection (ICNIRP) is the most respected one, and has been adopted so far by more than 80 countries. For radio stations, ICNIRP proposes two safety levels: one for occupational exposure, another one for the general population. Currently there are efforts underway to harmonise the different standards in existence.[26]
First, you must have a proper meter. To check for magnetic field emissions, an AC Gaussmeter will work. Most AC gaussmeters will have an internal probe. Simply position the gaussmeter on the phone. Note carefully where the meter is positioned. Make a call and watch the readings. Notice the highest and lowest readings, and make a mental note of the "average" reading. Now, insert the magnetic shield, and repeat.
This is a 2 pieces of plastic sandwiched together by glue. Don't believe me? Take it apart. This item works no better than the existing case on your phone. If you are that concerned with cellphone radiation, you should be equally concerned about the cheap plastic and toxic glue that this is comprised of. Also know the fact that they've stolen $25 from your wallet when you purchase this hokey product...Technology at it's finest.

The frequency of radiofrequency electromagnetic radiation ranges from 30 kilohertz (30 kHz, or 30,000 Hz) to 300 gigahertz (300 GHz, or 300 billion Hz). Electromagnetic fields in the radiofrequency range are used for telecommunications applications, including cell phones, televisions, and radio transmissions. The human body absorbs energy from devices that emit radiofrequency electromagnetic radiation. The dose of the absorbed energy is estimated using a measure called the specific absorption rate (SAR), which is expressed in watts per kilogram of body weight.
×