A phone's specific absorption rate (SAR) reveals the maximum amount of radiation the human body absorbs from the phone while it's transmitting. SAR testing ensures that the devices sold in the U.S. comply with the Federal Communications Commission (FCC) SAR exposure limit, but the single, worst-case value obtained from this SAR testing is not necessarily representative of the absorption during actual use, and therefore it is not recommended for comparisons among phones. In short, selecting a lower SAR phone will not reliably ensure lower radiation absorption during use. The FCC has more information at Specific Absorption Rate (SAR) For Cell Phones: What It Means For You.
You hit the nail on the head when you say that distance is key when it comes to EMF exposure. The solutions you sell will definitely help provide that separation. That said, our products are different in that they shield the user from EMF while allowing them to use the device as they normally would, without needing to hold their device by a rope or placing it in a faraday cage that eliminates signal altogether.
There are alternate technologies that can be considered when looking to reduce cell phone radiation exposure which we don’t use. Why don’t we use them? Incorporating technologies such as antennas into a case can greatly reduce outgoing cell phone radiation levels when close to the cell tower, but not totally. If farther away, the cell phone signal levels increase, as does the radiation exposure to the body, possibly to unacceptable output power levels. This design does not reduce radiation exposure from the WiFi and Bluetooth RF because cell phones do not have the capacity to reduce their power levels whether or not an antenna is present. Maybe just as important, this design does not have the shielding capacity for ELF emissions which have the same dangers as the RF emissions. Other device attachments like buttons and stickers are minimally effective to totally ineffective, with no scientific basis. In short, there are no other technologies capable of up to eliminating all of the many potentially harmful cell phone emissions from hitting the body.
Some studies have found a possible link. For example, several studies published by the same research group in Sweden have reported an increased risk of tumors on the side of the head where the cell phone was held, particularly with 10 or more years of use. It is hard to know what to make of these findings because most studies by other researchers have not had the same results, and there is no overall increase in brain tumors in Sweden during the years that correspond to these reports.
Third, most of the studies published so far have focused on adults, rather than children. (One case-control study looking at children and teens did not find a significant link to brain tumors, but the small size of the study limited its power to detect modest risks.) Cell phone use is now widespread even among younger children. It is possible that if there are health effects, they might be more pronounced in children because their bodies might be more sensitive to RF energy. Another concern is that children’s lifetime exposure to the energy from cell phones will be greater than adults’, who started using them at a later age.
Changing technology and methods of use. Older studies evaluated radiofrequency radiation exposure from analog cell phones. Today, cell phones use digital technology, which operates at a different frequency and a lower power level than analog phones. Digital cell phones have been in use for more than two decades in the United States, and cellular technology continues to change (3). Texting and other applications, for example, are common uses of cell phones that do not require bringing the phone close to the head. Furthermore, the use of hands-free technology, such as wired and wireless headsets, is increasing and may reduce exposure by distancing the phone from the body (36, 37).
EMF’s? Most everyone has grown up with EMF’s. It is not so much in your wifi as it is in your homes wiring. Check your walls and plugs with a meter. Also, every modern car is off the charts with EMF. Way I see it, people are living just fine. My grandmother is 86, living under power lines and house full of EMF electric wiring. She is fine. Unless I see 50% of the population dying early and having serious, serious issues, I will not panic over EMF’s
Open the “Step 2” packet and remove the cloth and rub the glass surface with the Ti22 Liquid Titanium Shield Nano liquid treated wipe which will coat the surface with the protective Nano liquid. The liquid needs to be applied for at least 90 seconds rubbing every part of the glass. Pushing gently into the glass to absorb the advanced formula. You can also use your finger to rub the liquid into the glass and don’t forget to apply to the camera lens and back-glass if you have a glass back. Allow the Ti22 Liquid Titanium Shield liquid to dry for at least 60-90 seconds before handling. Wash your hands carefully after the treatment.
The DefenderShield® Universal Cell Phone EMF Radiation Protection & RFID Blocking Wallet Case blocks up to virtually 100% of harmful EMF cell phone radiation from the face of your cell phone. This handcrafted case utilizes multi-layered, state-of-the-art radiation-shielding technology in the front cover while offering a soft microfiber interior and elegant vegan leather exterior resistive to scratching, staining and the accidental drop.
Our recommendation is to reduce your exposure from wireless sources. We advocate what’s referred to as the Precautionary Principle. Basically, this means that because there’s research, lots of it actually, saying the energy that powers our cellphones (RF radiation) could be causing health concerns like tumors and cancer. We ought to take care when using our cell phones and all devices that emit RF, using them mindfully.
From the FCC website: "The FCC ID number is usually shown somewhere on the case of the phone or device. In many cases, you will have to remove the battery pack to find the number. Once you have the number proceed as follows. Go to the following Web address: www.fcc.gov/oet/ea/fccid. Once you are there... Enter the FCC ID number (in two parts as indicated: 'Grantee Code' is comprised of the first three characters, the 'Equipment Product Code' is the remainder of the FCC ID). Then click on 'Start Search.' The grant of equipment authorization for this particular ID number should appear. The highest SAR values reported in the equipment certification test data are usually included in the comments section of the grant of equipment certification."
In conclusion: It is still unclear whether use of cellular technology is associated with an increased risk to develop malignant and benign tumors, but taking into account the results of recent studies, the Ministry of Health adopts the precautionary principle and follows the recommendations listed in the “Ministry of Health Recommendations” (below).
The frequency of radiofrequency electromagnetic radiation ranges from 30 kilohertz (30 kHz, or 30,000 Hz) to 300 gigahertz (300 GHz, or 300 billion Hz). Electromagnetic fields in the radiofrequency range are used for telecommunications applications, including cell phones, televisions, and radio transmissions. The human body absorbs energy from devices that emit radiofrequency electromagnetic radiation. The dose of the absorbed energy is estimated using a measure called the specific absorption rate (SAR), which is expressed in watts per kilogram of body weight.
×