Parents and consumer advocacy groups occasionally capture attention for voicing concerns about cellphones and other types of non-ionizing radio-frequency radiation exposure, such as the energy emitted from wifi routers in schools. In some cases, they have exaggerated what we know about the risks to kids, and rarely note that cellphones are also just one of many radiation sources we all live with. (Even the Earth itself, the air we breathe, and the sun and stars in our galaxy constantly give off radiation.)
Jump up ^ Repacholi MH, Lerchl A, Röösli M, Sienkiewicz Z, Auvinen A, Breckenkamp J, d'Inzeo G, Elliott P, Frei P, Heinrich S, Lagroye I, Lahkola A, McCormick DL, Thomas S, Vecchia P (2012). "Systematic review of wireless phone use and brain cancer and other head tumors". Bioelectromagnetics (Systematic review). 33 (3): 187–206. doi:10.1002/bem.20716. PMID 22021071.
So of course now that we understand that the cases are not tested and just the material--it makes sense! We measured power density levels all around the case-the shielding material most likely isn't used "all over" because then the phone couldn't receive signal and wouldn't be able to engage in a call. That's why we did not see even close to a 99% reduction when some cases were on the phone. In fact, watch the video and you'll see some readings are more than 20% higher with a case on vs the naked phone.
Open the “Step 1” packet and use the specially treated alcohol wipe to gently clean the glass surface and the back-glass section of the camera. If you have a phone with a glass back like the new iPhones, you can use this on both sides of the glass.Make sure all areas are clean and use until the cloth liquid has evaporated. Then you should use the soft microfiber to dry the glass before you go to step 2.
We began by getting a baseline of ambient RF in the room at the location of our testing. We then recorded a baseline of the cellphone RF while on an active call with no case. And finally, we measured the reduction in that baseline (still on the active call) using a variety of different cases and RF reducing products – all at the same set distance from the phone.
Several nations have advised moderate use of mobile phones for children. A journal by Gandhi et al. in 2006 states that children receive higher levels of Specific Absorption Rate (SAR). When 5- and 10-year olds are compared to adults, they receive about 153% higher SAR levels. Also, with the permittivity of the brain decreasing as one gets older and the higher relative volume of the exposed growing brain in children, radiation penetrates far beyond the mid-brain.
The amount of RF energy absorbed from the phone into the user’s body is known as the specific absorption rate (SAR). Different cell phones have different SAR levels. Cell phone makers are required to report the maximum SAR level of their product to the US Federal Communications Commission (FCC). This information can often be found on the manufacturer’s website or in the user manual for the phone. The upper limit of SAR allowed in the United States is 1.6 watts per kilogram (W/kg) of body weight.
EWG urges the FCC to include third party-produced cases and accessories in its cell phone testing policies to ensure that they do not compromise cell phone function and do not prevent a cell phone from complying with the Commission’s exposure limits. Manufacturers should publish the radiation data for a given phone when used directly next to the body and when used with the cases most commonly sold for a specific model.
The cell phone industry is fully aware of the dangers. In fact, enough scientific evidence exists that some companies’ service contracts prohibit suing the cell phone manufacturer or service provider, or joining a class action lawsuit. Still, the public is largely ignorant of the dangers, while the media regularly trumpets new studies showing cell phones are completely safe to use. Yet, Dr. Carlo points out, “None of those studies can prove safety, no matter how well they’re conducted or who’s conducting them.” What’s going on here? While the answer in itself is simplistic, how we got to this point is complex.
* This specification establishes the requirements for heat-sealable, electrostatic protective, flexible barrier materials used for the military packaging of microcircuits, sensitive semiconductor devices, sensitive resistors, and associated higher assemblies. In addition, the type I materials provide for water vapor-proof protection and attenuation of electromagnetic radiation.
“The near field plume is the one we’re most concerned with. This plume that’s generated within five or six inches of the center of a cell phone’s antenna is determined by the amount of power necessary to carry the signal to the base station,” he explains. “The more power there is, the farther the plume radiates the dangerous information-carrying radio waves.”
I received mine yesterday in the mail. I have a Samsung Galaxy Note 3, and I cannot use this sock unless I take the case off. This is one thing I did not know when I was purchasing this material. I am trying it out as stated, however even when I use a rubber case or a very thin case with the sock its very tight to get off. I think the manufacturer needs to allow more room in these and or not state that it fits the larger phones at 6 inch. They should state that without the case it will fit. I am in the first day of walking around without a case, and just the sleeve. Its different, and if I drop my phone I'm in a world of hurt. I like the idea of this, but I was also surprised when the material really only feels like felt. It's not like the RF fabric that I have seen, and hopefully this is some kind of special blocking material as stated. I do like the idea, and I agree that cell phone radiation exist. Ill come back and give five stars if I really notice a difference, however if I drop my phone because I dont have a case I'm going to be posting less stars.
The FCC provides information about the specific absorption rate (SAR) of cell phones produced and marketed within the last 1 to 2 years. The SAR corresponds with the relative amount of radiofrequency radiation absorbed by the head of a cell phone user (47). Consumers can access this information using the phone’s FCC ID number, which is usually located on the case of the phone, and the FCC’s ID search form.
Overall, the reviews of case-control studies seem to suggest there is perhaps no risk of cancer with cellphone use — unless you look at some subgroups (like people in blinded studies or people with long-term exposures). But these reviews are based on case-control studies — which are like the National Enquirer of the science world: cheap and often misleading.
He believes the FDA should put out guidance based on the results of the rat studies. “I would think it would be irresponsible to not put out indications to the public,” Melnick says. “Maintain a distance from this device from your children. Don’t sleep with your phone near your head. Use wired headsets. This would be something that the agencies could do right now.”
Current regulatory standards (SAR Test) only protect us from thermal or heating risks; yet, many hundreds of laboratory studies have found that low-intensity, non-thermal exposure to cell phone radiation can promote carcinogenic mechanisms. Moreover, research on humans has found that 25 years of mobile phone use is associated with a three-fold risk of brain cancer. –Joel M. Moskowitz, Ph.D. School of Public Health. University of California, Berkeley
An analysis of data from all 13 countries participating in the Interphone study reported a statistically significant association between intracranial distribution of tumors within the brain and self-reported location of the phone (7). However, the authors of this study noted that it is not possible to draw firm conclusions about cause and effect based on their findings.