* This specification establishes the requirements for heat-sealable, electrostatic protective, flexible barrier materials used for the military packaging of microcircuits, sensitive semiconductor devices, sensitive resistors, and associated higher assemblies. In addition, the type I materials provide for water vapor-proof protection and attenuation of electromagnetic radiation.

First, you must have a proper meter. To check for magnetic field emissions, an AC Gaussmeter will work. Most AC gaussmeters will have an internal probe. Simply position the gaussmeter on the phone. Note carefully where the meter is positioned. Make a call and watch the readings. Notice the highest and lowest readings, and make a mental note of the "average" reading. Now, insert the magnetic shield, and repeat.
Use the speaker mode on the phone or a hands-free device such as a corded or cordless earpiece. This moves the antenna away from your head, which decreases the amount of RF waves that reach the head. Corded earpieces emit virtually no RF waves (although the phone itself still emits small amounts of RF waves that can reach parts of the body if close enough, such as on the waist or in a pocket). Bluetooth® earpieces have an SAR value of around 0.001 watts/kg (less than one thousandth the SAR limit for cell phones as set by the FDA and FCC).
2. Our products are designed to provide an anti-radiation barrier between the device and the body. This way, the devices are still usable and able to send and receive signal out of the non-shielded side while shielding the EMF away from the body. Because of this, you will only see a reduction in EMF levels on the shielded side of the device. The test you have conducted shows the highest levels from anywhere around the device.

To find out about the state of research on the link between phones and cancer, we spoke with Jonathan Samet, dean of the Colorado School of Public Health and an expert in phone radiation who led a World Health Organization working group on the subject. In 2011, the WHO group deemed phone radiation “possibly carcinogenic,” which is less certain than other classifications, but isn’t an outright “no” either. Six years later, Samet said the evidence in either direction is still mixed and that for the time being, there remains “some indication” of risk.
For instance, our tests found that same case in the same location blocked more RF on a Verizon iPhone than it did on an AT&T iPhone. Neuert and other independent EMF experts tell us that was likely due to our proximity to the nearest respective cellphone towers. In a different location, or even facing a different direction, we may have seen different results.
In addition, cellphones potentially harm our health in ways that have nothing to do with cancer. The effect on sperm is concerning to Moskowitz, the director of the Center for Family and Community Health at the Berkeley School of Public Health, and he noted that our current cellphone regulations also don’t account for these potential effects. Plus, we still don’t know what steady exposure to this kind of radiation from devices means for kids.
Ty Bollinger is a happily married husband, the father of four wonderful children, devoted Christian, best-selling author, medical researcher, talk radio host, health freedom advocate, former competitive bodybuilder and also a certified public accountant.After losing several family members to cancer (including his mother and father), Ty refused to accept the notion that chemotherapy, radiation, and surgery were the most effective treatments available for cancer patients. He began a quest to learn all he possibly could about alternative cancer treatments and the medical industry. Ty has now made it his life mission to share the most remarkable discovery he made on his quest: the vast majority of all diseases (including cancer) can be easily prevented and even cured without drugs or surgery.Ty speaks frequently to health groups, at seminars, expos, conferences, churches, and is a regular guest on multiple radio shows and writes for numerous magazines and websites. Speaking from personal experience and extensive research, Ty has touched the hearts and changed the lives of thousands of people around the world.
If you want to measure the EMF radiation from your own phone, and know if EMF protection products are working, you should get a quality EMF meter. I highly recommend the new TriField TF2 (read my review) as it’s simple to use, lasts forever, is extremely accurate, and measures all three types of EMF radiation. If you’re looking for a low-cost EMF meter I really like the Meterk (read my review).
Launched at the U.S. Food and Drug Administration’s request 10 years ago, the NTP study dosed rats and mice of both sexes with RF radiation at either 1.5, 3 or 6 watts of radiation per kilogram of body weight, or W/kg. The lowest dose is about the same as the Federal Communications Commission’s limit for public exposure from cell phones, which is 1.6 watts W/kg. The animals were exposed nine hours a day for two years (about the average life span for a rat), and the exposures were cranked up steadily as the animals grew, so the absorbed doses per unit body weight remained constant over time.
Experts suggest that mobile phone users can take a number of precautions to reduce any possible health risks. Almost all agree that the best step is to keep mobile phone conversations short and to a minimum. Many believe that so-called hands free kits reduce the risks by cutting the amount of electromagnetic radiation entering the brain. They also recommend that users buy phones with external aerials so that it is as far away from the head as possible when in use. Similarly, it is believed that phones with a long talk time are more efficient and produce less powerful emissions. Users are also advised against buying handsets with a high “SAR” value, which means it emits more radiation.
The use of "hands-free" was not recommended by the British Consumers' Association in a statement in November 2000, as they believed that exposure was increased.[41] However, measurements for the (then) UK Department of Trade and Industry[42] and others for the French Agence française de sécurité sanitaire environnementale [fr][43] showed substantial reductions. In 2005, Professor Lawrie Challis and others said clipping a ferrite bead onto hands-free kits stops the radio waves travelling up the wire and into the head.[44]

The cellular phone industry was born in the early 1980s, when communications technology that had been developed for the Department of Defense was put into commerce by companies focusing on profits. This group, with big ideas but limited resources, pressured government regulatory agencies—particularly the Food and Drug Administration (FDA)—to allow cell phones to be sold without pre-market testing. The rationale, known as the “low power exclusion,” distinguished cell phones from dangerous microwave ovens based on the amount of power used to push the microwaves. At that time, the only health effect seen from microwaves involved high power strong enough to heat human tissue. The pressure worked, and cell phones were exempted from any type of regulatory oversight, an exemption that continues today. An eager public grabbed up the cell phones, but according to Dr. George Carlo, “Those phones were slowly prompting a host of health problems.”


The recent study [5] about cell phones causing cancer in rats should be taken with a grain of salt when making the connection to humans [6]. In particular, the rats in the study were exposed to radiation power densities of 0, 1.5, 3, or 6 W/kg (see p 7 in ref. 4 below). This would be equivalent of the 100 kg human getting up to 600 Watts — basically getting microwaved. As discussed earlier, cell phones are hundreds of times weaker.


Generally speaking, the near-field refers to the RF field close to the antenna and the far-field is the RF field further away from the antenna. Often times when you use your cell phone, your body is often located in the near-field (one wavelength or less) of the cell phone antenna. It is especially concerning when you hold your phone next to your head or wear it on your body as you can be exposed to very intense near-field radiation from the phone.
This SIM-style card is a little larger in size and attaches to the inside of the battery case with a quick peel and stick. Research shows the Bodywell reduces radiation by 65% on the iPhone 5, 80% on the Samsung Galaxy S3, and 35% on an iPad. This card could probably be used on smaller laptops, too. It's 30 day money back guarantee also makes it worth a look. For more information visit their website or view the reports for the iPhone 5, Samsung Galaxy SIII, and iPad. You can also watch this video.
I recently had a tumor removed from my abdomen that was stage 1 cancer. I was shocked considering my lifestyle is very clean – organic, vegetarian, active, live on acreage in semi-countryside, happy, stress free, etc….I immediately realized where it came from. It was right where I would set my iPAD in my lap when I am not at a table. There is no way to know for certain, but it is the only thing that makes sense.

EWG also reviewed data in the FCC filings on tests of battery life during a continuous call, measured on an iPhone 4 without a case and on the same phone with an Incipio Le Deux case. This case was chosen because it contains metallic parts (a stainless steel back plate). The presence of metallic components influences the phone’s radiation properties, as the FCC acknowledges (FCC 2001; FCC 2014). Under the test conditions with constant signal strength, an iPhone 4 without a case had 85 percent of battery capacity after a one-hour call and 70 percent after two hours. When the test was repeated with the Incipio Le Deux case, the phone had only 65 percent of battery capacity after a one-hour call and only 10 percent after two hours (Pong 2012).
One of the many advantages of TI22 is that after applying TI22 to your device it will have an invisible layer that will protect your device from harmful EMF radiation scratches and scuffs for up to one year. This layer reaches the full hardness of 9H on the Mohs scale of mineral hardness, which is a scale that characterizes scratch resistance, and is similar to Sapphire, Ruby or Corundum. Its almost as hard as a Diamond.
Cell phones emit low levels of radio frequency energy (i.e., radio frequency radiation) in the microwave range while being used. It is well known that high levels of RF can produce biological damage through heating effects (this is how your microwave oven is able to cook food). However, it is not known to what extent or through what mechanism, lower levels of RF might cause adverse health effects as well. Several research studies have shown that the radio frequency radiation from wireless phone antennae “appears to cause genetic damage in human blood,” while another case study uncovered a “statistically significant increase” in neuro-epithelial brain tumors among cell phone users. Other research has shown little or no adverse effects. ABC’s 20/20 News (May 26, 2000) took the five most popular phones sold in the US and tested them at a highly respected German laboratory. Four out of the five phones tested were above the SAR limit. One thing is for certain, similar to the case of cigarette smoking, it will take several tests and many years before the effects of radio frequency radiation on the human body are known.
"Partner Content" allows today's industry thought leaders to share their unique insight and perspective with the greater ASPENCORE audience. Material published as "Partner Content" was created by or on behalf of ASPENCORE's partner(s) in conjunction with the ASPENCORE Studio team and may not reflect the views of the site and editors to which it is published.For more information on this program, email support@aspencore.com
The FCC has yet to implement GAO’s recommendations to more closely reflect real-life use. For a narrow subset of smartphones – those sold with lanyards or straps – the FCC advises manufacturers to test phones at a distance of no more than 5 mm from the body (FCC 2014). Yet the FCC has done nothing to ensure more realistic testing of most other smartphones or to account for the widespread use of accessories such as cases, which many different manufacturers produce with both metallic and non-metallic components.

There is only one legitimate method of measuring cell phone radiation recognized by every major health authority and government in the world as well as by the cell phone industry itself, referred to as "SAR". SAR testing measures the "Specific Absorption Rate" of radiation at multiple depths and locations on the head and body in order to quantify how much radiation is actually penetrating it with and without certain safety devices. You can see a SAR test of the R2L device by watching the video below.


Jump up ^ Christopher Newman, et al. v Motorola, Inc., et al. (United States District Court for the District of Maryland) ("Because no sufficiently reliable and relevant scientific evidence in support of either general or specific causation has been proffered by the plaintiffs, as explained below, the defendants’ motion will be granted and the plaintiffs’ motion will be denied."). Text
This SIM-style card is a little larger in size and attaches to the inside of the battery case with a quick peel and stick. Research shows the Bodywell reduces radiation by 65% on the iPhone 5, 80% on the Samsung Galaxy S3, and 35% on an iPad. This card could probably be used on smaller laptops, too. It's 30 day money back guarantee also makes it worth a look. For more information visit their website or view the reports for the iPhone 5, Samsung Galaxy SIII, and iPad. You can also watch this video.
The frequency of radiofrequency electromagnetic radiation ranges from 30 kilohertz (30 kHz, or 30,000 Hz) to 300 gigahertz (300 GHz, or 300 billion Hz). Electromagnetic fields in the radiofrequency range are used for telecommunications applications, including cell phones, televisions, and radio transmissions. The human body absorbs energy from devices that emit radiofrequency electromagnetic radiation. The dose of the absorbed energy is estimated using a measure called the specific absorption rate (SAR), which is expressed in watts per kilogram of body weight.
×