The ultra thin (1mm) RadiCushion by Cellsafe slips into the cell phone case and redirects radiation away from the face of the phone. It's available in black or white but not recommended for use with aluminum or metallic cell phone cases. Test results show a SAR reduction of 96%. A slightly thicker (2mm) RadiCushion is available for iPad and iPad mini; it adheres to the back of the device and also provides SAR reductions of 96%. Visit their website for more information or watch this independent test which shows an 80% reduction and also compares it to the BlocSock:
Moving the meter around the case, we detect readings on the side, back and front of the case. We use the multi-directional TES 593 meter which measures 10 MHz to 8GHz. We use the unit of micro-watts per square centimeter, which looks like this little symbol: μW/cm² and we use it on the max setting which shows the maximum measured value. In non-science speak: the highest level of RF we see, which could be from the back the side or the front. 
✅ STOP CRIPPLING YOUR IMMUNE SYSTEM: Radiation waves have been shown to attack the human immune system, lowering our defences and making us prone to diseases and ailments. The special combination of crystals and minerals used in our EMF protection cell phone radiation shield will restore balance and increase the body’s defense against harmful radiation.
A phone's specific absorption rate (SAR) reveals the maximum amount of radiation the human body absorbs from the phone while it's transmitting. SAR testing ensures that the devices sold in the U.S. comply with the Federal Communications Commission (FCC) SAR exposure limit, but the single, worst-case value obtained from this SAR testing is not necessarily representative of the absorption during actual use, and therefore it is not recommended for comparisons among phones. In short, selecting a lower SAR phone will not reliably ensure lower radiation absorption during use. The FCC has more information at Specific Absorption Rate (SAR) For Cell Phones: What It Means For You.
First, you must have a proper meter. To check for magnetic field emissions, an AC Gaussmeter will work. Most AC gaussmeters will have an internal probe. Simply position the gaussmeter on the phone. Note carefully where the meter is positioned. Make a call and watch the readings. Notice the highest and lowest readings, and make a mental note of the "average" reading. Now, insert the magnetic shield, and repeat.

The information provided on this site is for informational purposes only and is not intended as a substitute for advice from your physician or other health care professional or any information contained on or in any product label or packaging. You should not use the information on this site for diagnosis or treatment of any health problem or for prescription of any medication or other treatment. You should consult with a healthcare professional before starting any diet, exercise or supplementation program, before taking any medication, or if you have or suspect you might have a health problem. You should not stop taking any medication without first consulting your physician.


5. Use an EMF shielding device. A variety of holsters and other cell phone holders and shields are available that claim to block radiation. If you buy such a product, look to see if it has an SAR (specific absorption rate) value. You want a shielding device that blocks the majority of EMFs. (SAR is a measure of the rate at which energy is absorbed by a body exposed to EMFs.) 

For now, it’s probably better not to spend too much of your time worrying: you’re surrounded by cellphone signals, Wi-Fi signals, and all other kinds of radio frequency radiation day in and out — not just when you put your phone up to your face. And until the evidence suggests otherwise, all of this is still considered less of a cancer risk than eating red meat (which you shouldn't freak out about that much either).
Our homemade demonstration of all the cases uses a working phone. Not the shielding material by itself, but the actual "shielding" SafeSleeve, Pong, Reach,  Vest, ShieldMe, and Defender Shield cases. First we get RF power density measurements from a phone that's on a call and then, in the same location, within minutes of the first reading, we place the same phone as it's engaged in a call into each case and we take additional reading with the meter.
Researchers have carried out several types of epidemiologic studies in humans to investigate the possibility of a relationship between cell phone use and the risk of malignant (cancerous) brain tumors, such as gliomas, as well as benign (noncancerous) tumors, such as acoustic neuroma (tumors in the cells of the nerve responsible for hearing that are also known as vestibular schwannomas), meningiomas (usually benign tumors in the membranes that cover and protect the brain and spinal cord), and parotid gland tumors (tumors in the salivary glands) (3).
×