I liked the way Blocsock implemented this protection and the quality of the product construction, combined with the validated test results, so I recently ordered ones for the rest of my family. I think Blocsock is the BMW-class of what I could find for products that protect against cell phone radiation. My wife has a larger Droid phone and it fits in the case (just barely though)! I hope the makers consider making a larger model for all the new, larger smartphones that recently came out with the larger screen sizes. Again, check to make sure your phone fits, which a friendly message to the company will answer if you are not sure.
People can also reduce their exposure by limiting cell-phone use when the cellular signal is weak; when traveling in a high-speed car, bus or train; to stream audio or video; or to download or upload large files. All of these circumstances cause phones to put out higher-than-normal levels of RF energy. Phones also emit RF energy when connected to WiFi or Bluetooth devices, but at lower levels.
Jump up ^ "Téléphones mobiles : santé et sécurité" (in French). Le ministère de la santé, de la jeunesse et des sports. 2 January 2008. Retrieved 19 January 2008. Lay article in (in English) making comment at Gitlin, Jonathan M. (3 January 2008). "France: Beware excessive cell phone use?: despite lack of data". Ars Technica. Retrieved 19 January 2008.
More often power off your phone or set it to airplane mode with Wi-Fi OFF and Bluetooth OFF. Even in standby mode, your phone emits RF energy because it is constantly searching for service or new messages. If you do not need your cell phone, simply power it off. This also applies to all other wireless devices whereby the Wi-Fi antennas can be powered off. Wi-Fi enabled laptops, tablets and other wireless devices (such as gaming devices) are always transmitting even if you are not using them, so remember to power them off.
A third requirement was for the FDA to create a formal interagency working group to oversee the work and provide input. The purpose of this was to alleviate any perception that the industry was paying for a result, not for the research itself. But the fourth and last requirement was considered by Dr. Carlo to be highly critical: “Everything needed to be done in sunlight. The media had to have access to everything we did.”
"To expect relief from radiation exposure from one specific device, is nearly impossible. It’s crucial to weigh in the MANY environmental factors; such as, temperature, atmospheric pressure, other radio waves, emissions from other devices, energy shifts from others around you, and Schumann Resonance shifts. Therefore," he explains that “relying on alteration of the environment as a safety precaution is always a game of chance…and signals affect people differently,” which adds another variables in the game of chance.
When the draft results of the papers were published earlier this year, all results were labeled “equivocal,” meaning the study authors felt the data weren’t clear enough to determine if the radiation caused the health effects or not. But the panel of peer reviewers (among them brain and heart pathologists, toxicologists, biostaticians, and engineers) re-evaluated the data and upgraded several of the conclusions to “some evidence” and “clear evidence.”
These cases work by redirecting the electromagnetic radiation (EMR) that is produced by phones, away from the user. All phones produce EMR when connected to the mobile network, and the effect of this energy is measured as a Specific Absorption Rate, or SAR: a measurement describing the radiation absorbed by kilogram of tissue. Government regulations in Australia dictate that all phones in Australia must emit a SAR less than 2 W/kg under the worst case scenario, and while all phones comply, most modern phones emit, at most, only half of this safe level, or approximately 1 W/kg.
Another thing that many people fail to realize is that EMF-emitting devices such as laptop computers are exceptionally more harmful when plugged in as opposed to when they’re operating on battery power alone. Tests have shown that working on a laptop that’s plugged in can result in up to 100 times more radiation exposure than using one that’s operating on battery power.
There is only one legitimate method of measuring cell phone radiation recognized by every major health authority and government in the world as well as by the cell phone industry itself, referred to as "SAR". SAR testing measures the "Specific Absorption Rate" of radiation at multiple depths and locations on the head and body in order to quantify how much radiation is actually penetrating it with and without certain safety devices. You can see a SAR test of the R2L device by watching the video below.
EMP Faraday Bags are designed to protect against damaging EMP current, static discharge, microwave transmission, RFID snooping and moisture damage. Protect your sensitive electronics (laptops, cellphones, iPads etc), precious memories (flash drives, floppy disks, tape recordings, etc) homeopathic remedies and medications, passports, credit cards and other devices from damage and spying. Could make all the difference if there is an EMP event or solar flare. Opening can be heat sealed with a hot iron for security reasons or long term storage. Manufacturer recommends that you “nest” items inside multiple layers of protection (double bagging) for best results.
This SIM-style card is a little larger in size and attaches to the inside of the battery case with a quick peel and stick. Research shows the Bodywell reduces radiation by 65% on the iPhone 5, 80% on the Samsung Galaxy S3, and 35% on an iPad. This card could probably be used on smaller laptops, too. It's 30 day money back guarantee also makes it worth a look. For more information visit their website or view the reports for the iPhone 5, Samsung Galaxy SIII, and iPad. You can also watch this video.
I just received this pouch today and it seems to be well-made. I did slide my phone into it (Droid Ultra) and it is snug, but fits. I think my son will also be able to put his ipod in the pouch which is helpful. I mostly bought this because my son puts his phone and ipod in his pocket all the time and I am concerned about the long-term effects of radiation exposure especially so close to his reproductive parts. Hopefully this will provide him with some protection from those elements.
RadiArmor’s anti-radiation material blocks over 99% of EMF radiation. However, since covering your entire phone with this material would result in no reception, only the front cover is lined with this material. This still provides an effective EMF reduction of 91% with no loss in reception. The front cover has a hole for sound to pass through so that you can close the case and talk at the same time.
Cell phones work by sending signals to (and receiving them from) nearby cell towers (base stations) using RF waves. This is a form of electromagnetic energy that falls between FM radio waves and microwaves. Like FM radio waves, microwaves, visible light, and heat, RF waves are a form of non-ionizing radiation. They don’t have enough energy to cause cancer by directly damaging the DNA inside cells. RF waves are different from stronger (ionizing) types of radiation such as x-rays, gamma rays, and ultraviolet (UV) light, which can break the chemical bonds in DNA.
Limit your (and your children’s) cell phone use. This is one of the most obvious ways to limit your exposure to RF waves from cell phones. You may want to use your cell phone only for shorter conversations, or use it only when a conventional phone is not available. Parents who are concerned about their children’s exposure can limit how much time they spend on the phone.
Over time, the number of cell phone calls per day, the length of each call, and the amount of time people use cell phones have increased. Because of changes in cell phone technology and increases in the number of base stations for transmitting wireless signals, the exposure from cell phone use—power output—has changed, mostly lowered, in many regions of the United States (1).