This substantially changes the debate on whether cell phone use is a cancer risk. Up until this point, the federal government and cell phone manufacturers operated on the assumption that cell phones cannot by their very nature cause cancer, because they emit non-ionizing radiation. Whereas ionizing radiation—the kind associated with x-rays, CT scans, and nuclear power plants, among others—definitely causes cancer at high enough doses, non-ionizing radiation was believed to not emit enough energy to break chemical bonds. That meant it couldn’t damage DNA, and therefore couldn’t lead to mutations that cause cancer.
During the years 1996-1999, due to the sharp increase in mobile phone use, several expert committees convened worldwide to discuss the question whether the radiowave radiation that is emitted from the mobile phone is harmful to health. Their conclusion was that existing scientific knowledge is insufficient to determine the existence or absence of harm to health.
Some products (http://www.safecell.net/reports01.html for example) are tested using a piece of shielding material in a laboratory test jig. These tests legitimately show the amount of radiation which penetrates the shield, but results will be very different when compared to putting a small amount of the same shield on a large transmitter like a cellphone. Remember, the entire phone radiates. Placing a small amount of shielding, even if it is an effective shielding material, only shields that small area at best. Think about this analogy: no light will penetrate a penny as it is a very effective light shield, but it is silly to think that holding a penny up to the sun will put you in darkness.
Cell phone radiation refers to radiation in the form of electromagnetic waves that is emitted from mobile phones. This type of radiation takes the form of radio waves that are near the microwave range. The amount of radiation that a given cell phone will emit depends on the exact frequency of the radiation, as well as whether the device is using an analog signal or a digital one. There has been speculation that large amounts of cell phone radiation could be hazardous to the user's health, but there are no conclusive scientific findings on the subject.
The following charts list SAR levels for the Apple iPhone, Samsung Galaxy S, as well as 20 of the highest SAR level cellphones and 20 of the lowest SAR level cellphones. The list provides the maximum possible SAR level from the phone (many phones have differing SAR levels depending on where and how the phone is used). If your phone is not on either list, you can find the SAR level for your specific phone by checking the online FCC database.
The research continued, and what it uncovered would be a dire warning to cell phone users and the industry’s worst nightmare. When the findings were ready for release in 1998, the scientists were suddenly confronted with another challenge: the industry wanted to take over public dissemination of the information, and it tried everything it could to do so. It was faced with disaster and had a lot to lose.
DefenderShield Cellphone Radiation Case also claims independent testing and says in their website: That a "sophisticated layering of separate non-toxic, human safe materials processed for maximum radiation blocking efficiency. Each material has unique and targeted radiation-shielding characteristics designed to work in unison to eliminate all radiation emissions from 0 to 10 GHZ and Defender Shield technology refracts, conducts and finally absorbs all these potentially harmful emissions." In this demonstration, the radiation level measured when DefendeShield case was on is still quite a bit above the level of exposure that I would recommend. I personally do not recommend-holding a phone with a shielding case to your head as the DefenderShield website shows a young woman doing as she demonstrates the product.
3. A lab setting is the only legitimate way to show the effectiveness of our technology for a few main reasons: one, a controlled source is the only way to conduct a scientific study. Note that the controlled source that we used was specifically designed to simulate emissions from wireless electronics (RF and ELF emissions of various frequencies). Two, ambient levels in a non-controlled environment will affect readings, rendering the results inaccurate. Three, at-home equipment such as the meter used in the video is not suitable for the types of emissions by a wireless device, nor are they reliable.
Anyway, several phone models that my wife and I considered buying emitted radiation levels simply too high for my comfort level. They’re measured in SAR -- “specific absorption rate” -- which is essentially the amount of radiation a human body will absorb from using or being near a cell phone. The lower the rate, the less radiation will be absorbed.
Disclaimer: The content of this website is based on research conducted by TTAC Publishing, LLC, unless otherwise noted. The information is presented for educational purposes only and is not intended to diagnose or prescribe for any medical or psychological condition, nor to prevent, treat, mitigate or cure such conditions. The information contained herein is not intended to replace a one-on-one relationship with a doctor or qualified healthcare professional. Therefore, this information is not intended as medical advice, but rather a sharing of knowledge and information based on research and experience. TTAC Publishing encourages you to make your own health care decisions based on your judgment and research in partnership with a qualified healthcare professional.