I debated whether to give it 3 or 4 stars: on features, speed of delivery, and quality of construction, it definitely deserves 4 stars. If I can measure and verify the emf reduction, then I will change the rating to 5 stars. Since the whole point of using it is to block excess em radiation, I can't really give it 5 stars without more proof that it really does so.
Cables can act as an antenna, especially if they pass close to a strong source of radiofrequency radiation. One study has suggested that if the cable of a hands free mic passes near the phone's antenna, it can pick up some radiation and transmit it to your ear. Our ferrite snap bead is designed to reduce RF radiation in the cable. Made in 2 halves, you simply press it around the hands free wire at any convenient location near the earpiece end. Couldn't be simpler. It is small and lightweight enough to be almost unnoticable, yet powerful enough (50 ohm impedence minimum) to control nasty radiation. These are brand new, top quality and will accommodate wires up to 5 mm (3/16 inch) in diameter. About 1 inch long, grey color. If you are concerned about radiation from your hands free ear mic, this is the answer. Useful from 200-1000 MHz.
Just why Schwann and glial cells appear to be targets of cell phone radiation is not clear. David Carpenter, a physician who directs the Institute for Health and the Environment at the University at Albany, S.U.N.Y., explained the purpose of these cells is to insulate nerve fibers throughout the body. These are electrical systems, so that may be some sort of factor, he wrote in an e-mail. “But this is only speculation.”

For those of you who experience (or want to prevent) ES symptoms in your hands when using a computer keyboard, laptop, cell phone or other electronic devices, these gloves form a conductive enclosure and effectively shield radiowaves and electric fields. Soft, light weight, with ribbed cuff, and offering good tactile sensitivity. Polyester fiber is twisted with pure Silver fibers, then knit into a stretchy glove shape in basic gray color. Each glove has a 1.7 mm snap for a ground cord. Fully hand washable and tested for 50 cycles with no appreciable loss of conductivity. All fibers are conductive, achieving resistivity of less than 10 Ohm/sq. These gloves are also used in industry for static control when working with delicate static sensitive components and can even be used for TENS applications. Grounding is not necessary for Faraday Cage shielding effect, but is necessary for static control. Also useful on touch screens like an iGlove. We do not have the ground cord which fits this snap on these gloves. Shielded Gloves:
Did you watch any of the videos? A healthy amount of skepticism is appropriate but be careful about just being a Debbie Downer. Admittedly, you haven’t tried all the products and probably aren’t even familiar with them yet quickly offer blanket assessments that it’s all marketing hype perpetuated by an evil Monopoly-man looking guy who just wants to take your money and snicker about what a sucker you are. Good luck with that.
But according to the FCC, comparing SAR values between phones can be misleading. The listed SAR value is based only on the phone operating at its highest power, not on what users would typically be exposed to with normal phone use. The actual SAR value during use varies based on a number of factors, so it’s possible that a phone with a lower listed SAR value might actually expose a person to more RF energy than one with a higher listed SAR value in some cases.
We used a few measuring devices to test and see if this product actually blocks radiation and RFID, including a very sophisticated EMF reader. I am glad to say that this is actually a very effective way to reduce radiation. It is most effective on the front side, and when you have it closed and latched, there is very little exposure - only along the top, side and bottom opening.
Moving the meter around the case, we detect readings on the side, back and front of the case. We use the multi-directional TES 593 meter which measures 10 MHz to 8GHz. We use the unit of micro-watts per square centimeter, which looks like this little symbol: μW/cm² and we use it on the max setting which shows the maximum measured value. In non-science speak: the highest level of RF we see, which could be from the back the side or the front. 
Only 0.010 inch thick, PaperSHIELD is flexible and can be easily cut with a scissors and shaped by hand into simple or very complex shapes. High saturation and moderate permeability make this ideal for shielding weak magnets, or stronger magnets with many layers of shielding. This material is particularly suited for achieving precise levels of partial shielding as you can add exactly the right number of layers to achieve the desired result. White paper on one side can be imprinted (by you). Peel and stick adhesive on the other side permits easy and semi-permanent mounting almost anywhere. Magnets will stick to it nicely.

Using a speaker/personal speakerphone or earplug (not wireless) during conversation - distancing the mobile phone from the user’s body reduces his exposure to the radiowave radiation. Therefore, keep the mobile phone at a distance from the body (do not carry it on the body, such as in the belt, pocket or on a neck strap). Obviously, reducing the amount and duration of calls on the mobile phone is another simple measure to reduce exposure.

SafeSleeve is garbage. And the customer service is even worse. I bought one in October 2017 and by the end of January 2018 the sticky patch had worn off to completely no longer be able to hold my phone. I contacted the company, and they would not replace it even though they recognized it was due to “normal wear” because they only have a 60 day warranty. And offered only a one-time 25% off coupon. for a $45 case only to be guaranteed for 2 months is absurd to me! I asked to be contacted by a manager as they do not have a phone number listed anywhere, just email address and has been a week and no response. Totally ignored.


All cell phones emit Electromagnetic Radiation (EMR). Most people are aware of Radio Frequency (RF) (also known as Microwave) signals that connect your cell phone to a cell tower, a WiFi router and Bluetooth devices. These cell phone signals are always on. But did you know that cell phones also emit Extremely Low Frequency (ELF) radiation produced by the cell phone’s internal components?
The exact source of radiation in a cell phone is from the transmitter, a device located near the antenna that converts audio data into electromagnetic waves. The amount of radiation a cell phone can emit is limited by legal restrictions in the U.S., Canada and Europe. Additionally, the average radiation levels of most mobile phones are available to the public, courtesy of the Federal Communications Commission in the U.S.
For now, it’s probably better not to spend too much of your time worrying: you’re surrounded by cellphone signals, Wi-Fi signals, and all other kinds of radio frequency radiation day in and out — not just when you put your phone up to your face. And until the evidence suggests otherwise, all of this is still considered less of a cancer risk than eating red meat (which you shouldn't freak out about that much either).

Bonus application! In addition to shielding magnetic fields, PaperSHIELD is also quite good at shielding radiowaves (cellphone, wifi, etc). And because of the adhesive backing, it can be adhered to almost any surface you need such as the inside or back of your cellphone case. (Use a near field meter to test RF shielding performance.) Note that it is not transparent, so it can't be used on the touch screen side. Cover the cut edges with sturdy tape as they can be sharp. 36 inches wide. Made in USA.
If you paid an electrical engineer to shield something for you, depending on the application, they would either use MuMetal or this type of mesh shielding. It’s not some new technology, so there’s no question of whether it works, because it does. Regardless, it would still be nice for them to publish third-party independent testing to reassure people of this.
Have you ever had headaches, eye problems, insomnia or dizziness because of too much time spent with your electronics? If so, you have probably been exposed to excessive Electromagnetic Radiation emitted from electronic devices such as cell phones and computers. Look after your wellbeing by using the Kyutec Radiation Blocker to wipe out negative waves by 97.17%. Take back control of your daily functional routine today!
Safe Cell Technology is created out of unique material that is permanently encoded with specific signals or frequencies designed to interact with and change the quality of the electromagnetic field (EMF) emitting from cell phones. It converts the electromagnetic energy into low level infrared energy acting as a cell phone radiation protection shield drastically reducing the harmful effects of cell phone radiation.
This is why it’s important to always use either your phone’s speakerphone or an appropriate wired earpiece whenever possible, avoiding direct contact between your phone and your ear or hand. The best earpieces are those equipped with hollow tubing between the antenna in the wire and the earpiece, as these help maximize the distance between the radiation-emitting antenna and your head.
So, what do these results in rodents mean for people? Not a whole lot, experts say. “Even with frequent daily use by the vast majority of adults, we have not seen an increase in events like brain tumors,” the FDA’s statement says. Otis Brawley, the American Cancer Society’s chief medical officer, agreed in an interview with The Associated Press. “The evidence for an association between cellphones and cancer is weak, and so far, we have not seen a higher cancer risk in people,” Brawley told the AP in a phone interview. “I am actually holding my cellphone up to my ear.”
Could you please provide me with evidence that non-ionizing radiation is damaging to humans? In another post illustrating the threats of non-ionizing radiation you have said that this radiation is damaging to children, and link an article by the American Academy of Sleep Medicine. However, this linked page contains no mention of non-ionizing radiation, and instead suggests that children are simply addicted to use of mobile phones, thus using them instead of sleeping. You also provided a link to a PubChem page on the negative effects of this radiation, but this page appears to no longer exist.
The authors found a consistent effect, in both types of studies, that cellphone radiation leads to decreased sperm motility (ability to swim) and viability, but not a decrease in overall concentration. While it’s unclear if these specific changes are enough to affect men’s fertility, the authors wrote, “mobile phone exposure may form part of a cumulative effect of modern day environmental exposures, that collectively reduce sperm quality and explain current trends in infertility.”
It'd be wrong to say that there is no evidence of harm at all. In fact, the re-classification by the IARC came about in the first place because the Working Group contributing to the Interphone study acknowledged "limited evidence" of an increase in glioma (a type of tumour, commonly found in the brain) among phone users in one of the studies. In this study, which concluded in 2004, researchers found that participating phone owners who had used their handsets for calls for more than 30-minutes a day, over a period of ten years, had an increase incidence of glioma.

So what do you do when you need a wireless radiation emitting device but you want to limit the exposure to the people? Perhaps you use a wireless baby monitor, have a cordless phone base station, or you sleep with your cell phone on your nightstand. Maybe there is a wifi router right next to you at work or school. RadiaFence is the answer. It’s a free-standing, semi-transparent microwave barrier that you can put almost anywhere you need. It blocks most of the radiation emitted in one direction by “casting a shadow” (typically 70-90% reduction), while still allowing the wireless device to work. Like sitting in the shade on a sunny day. Portable, inexpensive, attractive. And it couldn’t be easier to use. If you like, you can add a decorative photo or warning sign to change the appearance. Available in 5 styles. Pick the sizes which meet your needs. Style may differ from images.

Radiofrequency radiation is a form of electromagnetic radiation. Electromagnetic radiation can be categorized into two types: ionizing (e.g., x-rays, radon, and cosmic rays) and non-ionizing (e.g., radiofrequency and extremely low frequency, or power frequency). Electromagnetic radiation is defined according to its wavelength and frequency, which is the number of cycles of a wave that pass a reference point per second. Electromagnetic frequencies are described in units called hertz (Hz).
×