The amount of RF energy absorbed from the phone into the user’s body is known as the specific absorption rate (SAR). Different cell phones have different SAR levels. Cell phone makers are required to report the maximum SAR level of their product to the US Federal Communications Commission (FCC). This information can often be found on the manufacturer’s website or in the user manual for the phone. The upper limit of SAR allowed in the United States is 1.6 watts per kilogram (W/kg) of body weight.
Cell phones emit low levels of radio frequency energy (i.e., radio frequency radiation) in the microwave range while being used. It is well known that high levels of RF can produce biological damage through heating effects (this is how your microwave oven is able to cook food). However, it is not known to what extent or through what mechanism, lower levels of RF might cause adverse health effects as well. Several research studies have shown that the radio frequency radiation from wireless phone antennae “appears to cause genetic damage in human blood,” while another case study uncovered a “statistically significant increase” in neuro-epithelial brain tumors among cell phone users. Other research has shown little or no adverse effects. ABC’s 20/20 News (May 26, 2000) took the five most popular phones sold in the US and tested them at a highly respected German laboratory. Four out of the five phones tested were above the SAR limit. One thing is for certain, similar to the case of cigarette smoking, it will take several tests and many years before the effects of radio frequency radiation on the human body are known.
Fears that the low-energy radiation emitted by cellphones could cause cancer seem to have been simmering ever since cellphones went mainstream. The latest flare up is probably thanks to two things: an article in The Nation about “Big Wireless” and a government study that recently reported some male rats exposed to huge doses of full-body cellphone radiation developed a rare type of heart tumor.
SAR Shield was developed using the P.A.M. SYSTEM® technology. The materials used in the construction of the SAR Shield attract and dissipate electro-magnetic waves. As radiation travels it uses up its energy. What SAR Shield does is it acts like a radiation magnet, constantly attracting the radiation towards it, therefore making it release its energy closer to the phone. This causes most of the radiation to dissapate away from the head and body. SAR Shield does not cause noticeable reduction in signal strength.
A package for it is sold for 70 bucks that includes a choice from seven different color air-tube headsets in two styles (mono or stereo) with a ferrite bead already installed on the headset wire. A 4th accessory is included as a reminder that radiation is only shielded from the front of the phone when case is closed. The plastic stand enables a user to tilt the phone so that the unshielded sides and rear of the phone aren’t “inline-of-sight” with the body. Cell phone radiation, just as light, travels in a straight line. Being informed and awareness of using a phone safely is the most important aspect of RF Safe’s system of safe cell phone usage with 4 accessories for 69.99.
So of course now that we understand that the cases are not tested and just the material--it makes sense! We measured power density levels all around the case-the shielding material most likely isn't used "all over" because then the phone couldn't receive signal and wouldn't be able to engage in a call. That's why we did not see even close to a 99% reduction when some cases were on the phone. In fact, watch the video and you'll see some readings are more than 20% higher with a case on vs the naked phone.
Yes, the information transferred between the base unit (the phone’s stationary unit) and the wireless phone’s mobile unit is transferred as radiowave radiation. Therefore, the “precautionary principle” should also be adopted regarding wireless phones. In addition to the guidelines regarding mobile phones, the Ministry of Health recommends regarding wireless phones:
As our video points out: Measurements will vary with signal strength and other factors and that includes ambient energy. I talk about ambient energy in a lot of my videos-it's the energy that's in whatever environment I happen to be measuring in that's coming from a source of wireless energy that isn't the subject of what I'm measuring. My home is not a lab of course, but fortunately it's always measured very low for RF radiation.
One of the studies reports that male rats exposed to very high levels of radiofrequency radiation grew tumors around their hearts. Female rats exposed to the radiation didn’t, and neither male nor female mice showed obvious health problems in a second study. Neither study turned up clear evidence that radiofrequency radiation causes brain tumors, although the researchers are continuing to investigate. The studies are drafts that haven’t yet been reviewed by outside scientists.
There is only one legitimate method of measuring cell phone radiation recognized by every major health authority and government in the world as well as by the cell phone industry itself, referred to as "SAR". SAR testing measures the "Specific Absorption Rate" of radiation at multiple depths and locations on the head and body in order to quantify how much radiation is actually penetrating it with and without certain safety devices. You can see a SAR test of the R2L device by watching the video below.