The first one is easy, cellular frequencies vary between 450–2000MHz, but 800 or 900 MHz is the most common. The power emitted by a cell phone varies over the course of the call (higher when making initial contact, which lasts a few seconds). It can go up to 2 Watts at the start of a call, and can go down to .02 Watts during optimal operation [2]. Of course, most people barely use cell phones for calls, but I am using this example as a worst case scenario, because the phone is not right by your head when you are browsing Tinder.

Well, Loyd really does seems like a guy with great intentions! However, he has put too much faith in Pong’s SAR testing, and SAR guidelines in general — to the point he no-longer believes his own eye’s when nothing is observed on his trusty RF meter.   Which proves (Using an RF Meter) there is absolutely no real reduction in actual radiation coming from the front of the phone when a pong cell phone case is used.
Don’t rely on a “radiation shield” or other products claiming to block RF energy, electromagnetic fields, or radiation from cell phones. According to the U.S. Federal Trade Commission, products that interfere with the phone’s signal may force it to work harder and emit more RF energy in order to stay connected, possibly increasing your exposure. It is best to use wired solutions to reduce RF rather than rely on an untested  product.
Scientists have reported adverse health effects of using mobile phones including changes in brain activity, reaction times, and sleep patterns. More studies are underway to try to confirm these findings. When mobile phones are used very close to some medical devices (including pacemakers, implantable defibrillators, and certain hearing aids) there is the possibility of causing interference with their operation. There is also the potential of interference between mobile phones signals and aircraft electronics. Some countries have licensed mobile phone use on aircraft during flight using systems that control the phone output power.

Participation bias, which can happen when people who are diagnosed with brain tumors are more likely than healthy people (known as controls) to enroll in a research study. Also, controls who did not or rarely used cell phones were less likely to participate in the Interphone study than controls who used cell phones regularly. For example, the Interphone study reported participation rates of 78% for meningioma patients (range among the individual studies 56–92%), 64% for glioma patients (range 36–92%), and 53% for control subjects (range 42–74%) (6).

The amount of RF energy absorbed from the phone into the user’s body is known as the specific absorption rate (SAR). Different cell phones have different SAR levels. Cell phone makers are required to report the maximum SAR level of their product to the US Federal Communications Commission (FCC). This information can often be found on the manufacturer’s website or in the user manual for the phone. The upper limit of SAR allowed in the United States is 1.6 watts per kilogram (W/kg) of body weight.
Radiofrequency radiation is a form of electromagnetic radiation. Electromagnetic radiation can be categorized into two types: ionizing (e.g., x-rays, radon, and cosmic rays) and non-ionizing (e.g., radiofrequency and extremely low frequency, or power frequency). Electromagnetic radiation is defined according to its wavelength and frequency, which is the number of cycles of a wave that pass a reference point per second. Electromagnetic frequencies are described in units called hertz (Hz).
×