There is only one legitimate method of measuring cell phone radiation recognized by every major health authority and government in the world as well as by the cell phone industry itself, referred to as "SAR". SAR testing measures the "Specific Absorption Rate" of radiation at multiple depths and locations on the head and body in order to quantify how much radiation is actually penetrating it with and without certain safety devices. You can see a SAR test of the R2L device by watching the video below.
Dr Davis holds a B.S. in physiological psychology and an M.A. in sociology from the University of Pittsburgh, 1967. She completed a PhD in science studies at the University of Chicago as a Danforth Foundation Graduate Fellow, 1972 and a M.P.H. in epidemiology at the Johns Hopkins University as a Senior National Cancer Institute Post-Doctoral Fellow, 1982. She has authored more than 200 publications and has been published in Lancet and Journal of the American Medical Association as well as the Scientific American and the New York Times.
Don’t rely on a “radiation shield” or other products claiming to block RF energy, electromagnetic fields, or radiation from cell phones. According to the U.S. Federal Trade Commission, products that interfere with the phone’s signal may force it to work harder and emit more RF energy in order to stay connected, possibly increasing your exposure. It is best to use wired solutions to reduce RF rather than rely on an untested product.
“This means we’re on the beginning curve of an epidemic, with epidemic defined as a change in the occurrence of a disease that is so dramatic in its increase that it portends serious public health consequences,” says Dr. Carlo. “This is what’s not being told to the public. One of the things that I suggest to people who use a cell phone is to use an air tube headset. If you use a wired headset, the current moving through the wire of the headset attracts ambient informational carrying radio waves and thereby increases your exposure.”
If you paid an electrical engineer to shield something for you, depending on the application, they would either use MuMetal or this type of mesh shielding. It’s not some new technology, so there’s no question of whether it works, because it does. Regardless, it would still be nice for them to publish third-party independent testing to reassure people of this.
Using the gauss meter at varied locations, you can easily detect electromagnetic radiation “hot spots” where exposure to these ominous frequencies is the greatest. Armed with this crucial information, you can then avoid these areas, re-arranging furniture or electronic devices as needed in order to avoid unnecessary exposure to electromagnetic radiation.
To check for radiowave emissions, use an RF meter with Near Field antenna. Again, position the antenna loop on the phone (because the entire antenna stem has some sensitivity, it is best to position the entire antenna over the area that will be shielded). Note carefully where the loop is positioned. Make a call and watch the readings. Notice the highest and lowest readings, and make a mental note of the "average" reading. Now, insert the shield, and repeat.
What the study showed: Most published analyses from this study have shown no statistically significant increases in brain or central nervous system cancers related to higher amounts of cell phone use. One analysis showed a statistically significant, although modest, increase in the risk of glioma among the small proportion of study participants who spent the most total time on cell phone calls. However, the researchers considered this finding inconclusive because they felt that the amount of use reported by some respondents was unlikely and because the participants who reported lower levels of use appeared to have a slightly reduced risk of brain cancer compared with people who did not use cell phones regularly (4–6).