There are alternate technologies that can be considered when looking to reduce cell phone radiation exposure which we don’t use. Why don’t we use them? Incorporating technologies such as antennas into a case can greatly reduce outgoing cell phone radiation levels when close to the cell tower, but not totally. If farther away, the cell phone signal levels increase, as does the radiation exposure to the body, possibly to unacceptable output power levels. This design does not reduce radiation exposure from the WiFi and Bluetooth RF because cell phones do not have the capacity to reduce their power levels whether or not an antenna is present. Maybe just as important, this design does not have the shielding capacity for ELF emissions which have the same dangers as the RF emissions. Other device attachments like buttons and stickers are minimally effective to totally ineffective, with no scientific basis. In short, there are no other technologies capable of up to eliminating all of the many potentially harmful cell phone emissions from hitting the body.
For example, cellphone manufacturers currently test these devices for compliance with FCC standards by placing them against the head, and near the torso with some separation. Just check out Apple’s iPhone manual: The company tests the specific absorption rate at a 5mm separation from the body. But if you wear your device in your pocket, you’re probably not going to have that 5mm separation, meaning you may be exposed to more radiation — perhaps enough to exceed current standards.
More often power off your phone or set it to airplane mode with Wi-Fi OFF and Bluetooth OFF. Even in standby mode, your phone emits RF energy because it is constantly searching for service or new messages. If you do not need your cell phone, simply power it off. This also applies to all other wireless devices whereby the Wi-Fi antennas can be powered off. Wi-Fi enabled laptops, tablets and other wireless devices (such as gaming devices) are always transmitting even if you are not using them, so remember to power them off.
But, like the human studies, one can pick apart the NTP studies too. For one thing, the animals experienced cell phone radiation that was different from what humans live with. As Bucher said in a statement, “In our studies, rats and mice received radio frequency radiation across their whole bodies. By contrast, people are mostly exposed in specific local tissues close to where they hold the phone. In addition, the exposure levels and durations in our studies were greater than what people experience.”
We really do not recommend any kind of chip, guard, anti-radiation "filters" or incomplete shielding case because honestly, how could they NOT provide a false sense of security? Folks could believe these products make them “invincible” against radiation so they are comfortable holding the case right up to their heads-and the radiation seeping from the back and the side of the phone case is in very close proximity to their precious brains. Oh no!
You hit the nail on the head when you say that distance is key when it comes to EMF exposure. The solutions you sell will definitely help provide that separation. That said, our products are different in that they shield the user from EMF while allowing them to use the device as they normally would, without needing to hold their device by a rope or placing it in a faraday cage that eliminates signal altogether.
Great article. I learned several things that I will put into use with my electronic technology. Thank you. There are numerous EMF/EMR blockers that you can stick on your cell phones, computers, (even microwave ovens for people who still use these). Each brand I’ve researched has the same goal but they’re all different. Are some brands more effective than others? If you can recommend some good brands, I would appreciate your advice. What are good features to look for when selecting the EMF blockers?

The studies are notable for their sizes. Researchers at the National Toxicology Program, a federal interagency group under the National Institutes of Health, tested 3,000 rats and mice of both sexes for two years—the largest investigation of RF radiation and cancer in rodents ever undertaken in the U.S. European investigators at the Ramazzini Institute in Italy were similarly ambitious; in their recent study they investigated RF effects in nearly 2,500 rats from the fetal stage until death.
I also searched around to see if cell phone radiation was anything to worry about anyway. I turned up enough information from a lot of different credible sources to convince me it was worth protecting against the possible damaging effects of this radiation. IF there is no real health impact, then having a protective device would be overkill, but I figured better overkill than discover in time people started developing problems as a result of heavy cell phone use.

Our homemade demonstration of all the cases uses a working phone. Not the shielding material by itself, but the actual "shielding" SafeSleeve, Pong, Reach,  Vest, ShieldMe, and Defender Shield cases. First we get RF power density measurements from a phone that's on a call and then, in the same location, within minutes of the first reading, we place the same phone as it's engaged in a call into each case and we take additional reading with the meter.
A large prospective (forward-looking) study of nearly 800,000 women in the UK examined the risk of developing brain tumors over a 7-year period in relation to self-reported cell phone use at the start of the study. This study found no link between cell phone use and brain tumors overall or several common brain tumor subtypes, but it did find a possible link between long-term cell phone use and acoustic neuromas.

Pong’s claims for its case have stood up to the scrutiny of Wired magazine and the Better Business Bureau (Advertising Self-Regulation Council 2012; Ganapati 2009). In tests conducted by Cetecom, a cell phone radiation certification lab, and observed by a reporter from Wired magazine, an iPhone 3G tested without a case had a maximum SAR of 1.18 W/kg when held at the ear. The same phone tested with a Pong case had a maximum SAR of 0.42 W/kg (Ganapati 2009).  
But, like the human studies, one can pick apart the NTP studies too. For one thing, the animals experienced cell phone radiation that was different from what humans live with. As Bucher said in a statement, “In our studies, rats and mice received radio frequency radiation across their whole bodies. By contrast, people are mostly exposed in specific local tissues close to where they hold the phone. In addition, the exposure levels and durations in our studies were greater than what people experience.”

EWG believes that cell phone testing procedures should include cases and other accessories, whether supplied by the phone manufacturer or a third party. Since these cases and accessories have no other use and have the potential to influence the phone’s transmitting and receiving activity and the amount of radiation that a user might encounter, they fall within FCC’s authority.


Exposure to ionizing radiation, such as from x-rays, is known to increase the risk of cancer. However, although many studies have examined the potential health effects of non-ionizing radiation from radar, microwave ovens, cell phones, and other sources, there is currently no consistent evidence that non-ionizing radiation increases cancer risk in humans (2).
×