The next scientific step will be to determine what this means for humans. The peer-reviewed papers will be passed on to the US Food and Drug Administration, which is responsible for determining human risk and issuing any guidelines to the public, and the Federal Communications Commission, which develops safety standards for cell phones. The FDA was part of the group of federal agencies who commissioned the studies back in the early 2000s.
Since speaking with Samet, further details came out from a large study that beamed high levels of phone radiation at rats and mice. While there remain quirks in the findings, the latest evidence still doesn’t find a link between phone radiation and cancer. In response, the FDA said, “Taken together, all of this research ... [has] given us the confidence that the current safety limits for cell phone radiation remain acceptable for protecting the public health.”
Cables can act as an antenna, especially if they pass close to a strong source of radiofrequency radiation. One study has suggested that if the cable of a hands free mic passes near the phone's antenna, it can pick up some radiation and transmit it to your ear. Our ferrite snap bead is designed to reduce RF radiation in the cable. Made in 2 halves, you simply press it around the hands free wire at any convenient location near the earpiece end. Couldn't be simpler. It is small and lightweight enough to be almost unnoticable, yet powerful enough (50 ohm impedence minimum) to control nasty radiation. These are brand new, top quality and will accommodate wires up to 5 mm (3/16 inch) in diameter. About 1 inch long, grey color. If you are concerned about radiation from your hands free ear mic, this is the answer. Useful from 200-1000 MHz.
“Epidemiological studies are targets for fixing the outcome because they’re observational in nature instead of experimental,” Dr. Carlo explains. “It’s possible to design studies with pre-determined outcomesthat still fall within the range of acceptable science. Thus, even highly flawed epidemiological studies can be published in peer-reviewed journals because they’re judged against a pragmatic set of standards that assume the highest integrity among the investigators.”
Only 0.010 inch thick, PaperSHIELD is flexible and can be easily cut with a scissors and shaped by hand into simple or very complex shapes. High saturation and moderate permeability make this ideal for shielding weak magnets, or stronger magnets with many layers of shielding. This material is particularly suited for achieving precise levels of partial shielding as you can add exactly the right number of layers to achieve the desired result. White paper on one side can be imprinted (by you). Peel and stick adhesive on the other side permits easy and semi-permanent mounting almost anywhere. Magnets will stick to it nicely.
We used a few measuring devices to test and see if this product actually blocks radiation and RFID, including a very sophisticated EMF reader. I am glad to say that this is actually a very effective way to reduce radiation. It is most effective on the front side, and when you have it closed and latched, there is very little exposure - only along the top, side and bottom opening.
According to the FTC, there is no scientific proof that so-called shields significantly reduce exposure from electromagnetic emissions. Products that block only the earpiece – or another small portion of the phone – are totally ineffective because the entire phone emits electromagnetic waves. Such shields "may interfere with the phone's signal, cause it to draw even more power to communicate with the base station, and possibly emit more radiation." The FTC has enforced false advertising claims against companies that sell such products.
Moving the meter around the case, we detect readings on the side, back and front of the case. We use the multi-directional TES 593 meter which measures 10 MHz to 8GHz. We use the unit of micro-watts per square centimeter, which looks like this little symbol: μW/cm² and we use it on the max setting which shows the maximum measured value. In non-science speak: the highest level of RF we see, which could be from the back the side or the front.
Apple has designed the 3D touch screens on newer models of the iPhone such as iPhone 6S, iPhone 6S Plus, iPhone 7 and iPhone 7 Plus models to have adjustable screen sensitivity. If your phone is acting unexpectedly when closing the cover of your case, this can be easily solved by adjusting the sensitivity of the touchscreen in your phone settings. Go to Settings > General > Accessibility > 3D Touch. You can either turn this feature completely OFF or set the sensitivity slider to FIRM to make the the 3D touch screen less sensitive.
But, like the human studies, one can pick apart the NTP studies too. For one thing, the animals experienced cell phone radiation that was different from what humans live with. As Bucher said in a statement, “In our studies, rats and mice received radio frequency radiation across their whole bodies. By contrast, people are mostly exposed in specific local tissues close to where they hold the phone. In addition, the exposure levels and durations in our studies were greater than what people experience.”
The cellular phone industry was born in the early 1980s, when communications technology that had been developed for the Department of Defense was put into commerce by companies focusing on profits. This group, with big ideas but limited resources, pressured government regulatory agencies—particularly the Food and Drug Administration (FDA)—to allow cell phones to be sold without pre-market testing. The rationale, known as the “low power exclusion,” distinguished cell phones from dangerous microwave ovens based on the amount of power used to push the microwaves. At that time, the only health effect seen from microwaves involved high power strong enough to heat human tissue. The pressure worked, and cell phones were exempted from any type of regulatory oversight, an exemption that continues today. An eager public grabbed up the cell phones, but according to Dr. George Carlo, “Those phones were slowly prompting a host of health problems.”
It also means regulators need to make sure their policies reflect new levels of exposure. The Federal Communications Commission currently oversees cellphone safety and sets the limits for how much radiation people should be exposed to. (This is measured by the specific absorption rate — the rate at which the body absorbs radio frequency energy — and the current limit for cellphones is 1.6 watts of energy per kilogram of tissue. The whole-body threshold is a SAR value of 0.08 watts per kilogram, and the tower radiation limit is 10 watts per square meter.)
Like we talked about in the last section, SAR limits that are reported are the maximum possible radiation emitted from the device, however, this level is not what is common with the regular use of the device. Just because one cell phone has a higher maximum SAR level, doesn’t mean that the radiation level of normal use isn’t higher or lower than another device with a different maximum SAR level.
The recent study  about cell phones causing cancer in rats should be taken with a grain of salt when making the connection to humans . In particular, the rats in the study were exposed to radiation power densities of 0, 1.5, 3, or 6 W/kg (see p 7 in ref. 4 below). This would be equivalent of the 100 kg human getting up to 600 Watts — basically getting microwaved. As discussed earlier, cell phones are hundreds of times weaker.
Morbidity and mortality among study participants who have brain cancer. Gliomas are particularly difficult to study, for example, because of their high death rate and the short survival of people who develop these tumors. Patients who survive initial treatment are often impaired, which may affect their responses to questions. Furthermore, for people who have died, next-of-kin are often less familiar with the cell phone use patterns of their deceased family member and may not accurately describe their patterns of use to an interviewer.