I also searched around to see if cell phone radiation was anything to worry about anyway. I turned up enough information from a lot of different credible sources to convince me it was worth protecting against the possible damaging effects of this radiation. IF there is no real health impact, then having a protective device would be overkill, but I figured better overkill than discover in time people started developing problems as a result of heavy cell phone use.
All cell phones emit Electromagnetic Radiation (EMR). Most people are aware of Radio Frequency (RF) (also known as Microwave) signals that connect your cell phone to a cell tower, a WiFi router and Bluetooth devices. These cell phone signals are always on. But did you know that cell phones also emit Extremely Low Frequency (ELF) radiation produced by the cell phone’s internal components?
To find out about the state of research on the link between phones and cancer, we spoke with Jonathan Samet, dean of the Colorado School of Public Health and an expert in phone radiation who led a World Health Organization working group on the subject. In 2011, the WHO group deemed phone radiation “possibly carcinogenic,” which is less certain than other classifications, but isn’t an outright “no” either. Six years later, Samet said the evidence in either direction is still mixed and that for the time being, there remains “some indication” of risk.
While the Federal Communication Commission limits how much radiofrequency radiation can come out of your cellphone, the Food and Drug Administration can have a say about whether those limits are safe. So the FDA asked the National Toxicology Program (NTP), a division within the National Institutes of Health, to investigate. Based on the NTP’s results, as well as hundreds of other studies, the FDA is still confident that the current limits on cellphone radiation are safe, according to a statement from Jeffrey Shuren, the director of the FDA’s Center for Devices and Radiological Health.
With the background levels of information-carrying radio waves dramatically increasing because of the widespread use of cell phones,Wi-Fi, and other wireless communication, the effects from the near and far-fields are very similar. Overall, says Dr. Carlo, almost all of the acute and chronic symptoms seen in electrosensitive patients can be explained in some part by disrupted intercellular communication. These symptoms of electrosensitivity include inability to sleep, general malaise, and headaches. Could this explain the increase in recent years of conditions such as attention-deficit hyperactivity disorder (ADHD), autism, and anxiety disorder?
Our recommendation is to reduce your exposure from wireless sources. We advocate what’s referred to as the Precautionary Principle. Basically, this means that because there’s research, lots of it actually, saying the energy that powers our cellphones (RF radiation) could be causing health concerns like tumors and cancer. We ought to take care when using our cell phones and all devices that emit RF, using them mindfully.
“Epidemiological studies are targets for fixing the outcome because they’re observational in nature instead of experimental,” Dr. Carlo explains. “It’s possible to design studies with pre-determined outcomesthat still fall within the range of acceptable science. Thus, even highly flawed epidemiological studies can be published in peer-reviewed journals because they’re judged against a pragmatic set of standards that assume the highest integrity among the investigators.”
Cellsafe backs its claims by publishing independent test results on its site. These test reports are detailed, complex and confusing, but the results are available for you to interpret. For example, their tests found that an iPhone 4S produced a SAR of 1.069 W/kg on the 3G 2100Mhz frequency without a case, and 0.267 W/kg with a Cellsafe case. But what in the world does that actually mean? Is a SAR of 1 W/kg dangerous? Is a reduction to 0.267 W/kg actually better, or are we just splitting hairs?
When turned on, cell phones and other wireless devices emit RF radiation continually, even if they are not being actively used, because they are always communicating with cell towers. The dose intensity tails off with increasing distance from the body, and reaches a maximum when the devices are used next to the head during phone calls or in front of the body during texting or tweeting.
Educate yourself about the RF sources in your home, and replace the devices that you can with non-wireless alternatives, and replace the wireless connections that you can with wired ethernet or other cord/cable connections. Note: most wireless devices can connect non-wirelessly, sometimes an easy-to-find adaptor accessory is required to use cords/cables.
The cell phone industry constantly guards its financial interests, but unfortunately, an unwitting public can be harmed in the process, says Dr. Carlo. “Industry-funded studies in many cases now produce industry-desired outcomes. By tampering with the integrity of scientists, scientific systems and public information steps over the lines of propriety that are appropriate for protecting business interests—especially when the casualty of the interference is public health and safety.”
The studies are notable for their sizes. Researchers at the National Toxicology Program, a federal interagency group under the National Institutes of Health, tested 3,000 rats and mice of both sexes for two years—the largest investigation of RF radiation and cancer in rodents ever undertaken in the U.S. European investigators at the Ramazzini Institute in Italy were similarly ambitious; in their recent study they investigated RF effects in nearly 2,500 rats from the fetal stage until death.
We began by getting a baseline of ambient RF in the room at the location of our testing. We then recorded a baseline of the cellphone RF while on an active call with no case. And finally, we measured the reduction in that baseline (still on the active call) using a variety of different cases and RF reducing products – all at the same set distance from the phone.
A recent large study by the US National Toxicology Program (NTP) exposed large groups of lab rats and mice to RF energy over their entire bodies for about 9 hours a day, starting before birth and continuing for up to 2 years (which is the equivalent of about 70 years for humans, according to NTP scientists). The study found an increased risk of tumors called malignant schwannomas of the heart in male rats exposed to RF radiation, as well as possible increased risks of certain types of tumors in the brain and adrenal glands. But some aspects of this study make it hard to know just how well these results might be applied to cell phone use in people. For example, there was no clear increased risk among female rats or among male or female mice in the study. The doses of RF radiation in the study were also generally higher than those used in cell phones (ranging from 1.5 W/kg to 6 W/kg in rats, and 2.5 W/kg to 10 W/kg in mice), the animals’ entire bodies were exposed, and the amount of time they were exposed was longer than most people typically spend on the phone each day. The male rats in the study exposed to RF waves also lived longer, on average, than the rats who were not exposed, for unclear reasons. Because of this, the NTP has noted that the study results cannot be directly applied to humans. Still, the results add to the evidence that cell phone signals might potentially impact human health.
Don’t rely on a “radiation shield” or other products claiming to block RF energy, electromagnetic fields, or radiation from cell phones. According to the U.S. Federal Trade Commission, products that interfere with the phone’s signal may force it to work harder and emit more RF energy in order to stay connected, possibly increasing your exposure. It is best to use wired solutions to reduce RF rather than rely on an untested product.
(Some common flaws in these studies: The summaries of the evidence weren’t comprehensive, the researchers often didn’t look at the quality of the studies they found, and they failed to do other simple things that would limit bias from creeping in. They also relied on case-control studies, a poor method to determine causality — more on that soon.) So we didn’t include these eight reviews in our analysis.
That mystery probably stokes fears about cellphone radiation instead of soothing them, though — in part because of how we in the media cover the rare and frightening. We’ve seen the same thing with fear over nuclear power plants, according to a paper published in Science in the 1980s by psychologist Paul Slovic. “Because nuclear risks are perceived as unknown and potentially catastrophic, even small accidents will be highly publicized and may produce large ripple effects,” Slovic wrote.
Cooper's prototype arrived on the market a decade later at the staggering price of $3,995. Designed by Rudy Krolopp, it was known as the Motorola DynaTAC 8000X, or simply "the brick.” Featuring 20 large buttons and a long rubber antenna, it measured about 11 inches high, weighed almost 2 pounds, provided one hour of battery life and could store 30 phone numbers.
So, what types of RF are these cases intended to block? If they block the frequency being used by the phone than if the blocking is complete the phone won’t work. If it’s partial than, as noted by the FCC and related in the article, the phone may attempt to compensate for the weakened signal by increasing it’s signal strength, thereby emitting higher levels of radiation itself, and reducing battery life in the process.
Only 0.010 inch thick, PaperSHIELD is flexible and can be easily cut with a scissors and shaped by hand into simple or very complex shapes. High saturation and moderate permeability make this ideal for shielding weak magnets, or stronger magnets with many layers of shielding. This material is particularly suited for achieving precise levels of partial shielding as you can add exactly the right number of layers to achieve the desired result. White paper on one side can be imprinted (by you). Peel and stick adhesive on the other side permits easy and semi-permanent mounting almost anywhere. Magnets will stick to it nicely.
INTEGRITY: Many manufactures claim near 100% EMF protection, referring to the radiation blocking material, NOT the protection you receive on a call. If you covered your whole phone with EMF blocking material, then you'd have no signal. Our EMF blocking material is used on the front cover only, providing you real EMF protection with no sacrifice in reception.