But this study also has some drawbacks. First, it is based only on whether or not people had a cell phone subscription at the time. It didn’t measure how often these people used their phones (if at all), or if people who didn’t have a subscription used someone else’s phone. There are also limits as to how well this study might apply to people using cell phones today. For example, while the cell phones used at the time of the study tended to require more power than modern cell phones, people also probably used the phones quite a bit less than people use their phones today.
The city council of Berkeley, Calif., has also acted. In May 2015, it approved a “Right to Know” law that requires electronics retailers to notify consumers about the proper handling of cell phones. CTIA-The Wireless Association, a trade group, is now trying to block that law from going into effect, as it successfully did after San Francisco passed its own Right to Know law five years ago.

It also means regulators need to make sure their policies reflect new levels of exposure. The Federal Communications Commission currently oversees cellphone safety and sets the limits for how much radiation people should be exposed to. (This is measured by the specific absorption rate — the rate at which the body absorbs radio frequency energy — and the current limit for cellphones is 1.6 watts of energy per kilogram of tissue. The whole-body threshold is a SAR value of 0.08 watts per kilogram, and the tower radiation limit is 10 watts per square meter.)


This is the second Cell Shield protector I have purchased. I have had one for my cell phone for almost a year now and it has been wonderful! When my husband upgraded to a new phone, I knew I needed to purchase one for him. The application of the button is very simple and it stays on well. Due to the fact that it is a 'raised' button (a few millimeters thick), some may find it difficult to know where to apply it. I have an i4 phone with an Otterbox case. There is a round cut-out hole in the case that lines up with the 'apple' symbol on the back of the phone. I was able to place the button in that cut-out and it lines up flush with the cover. I highly recommend this Protector to anyone looking to significantly and effectively block EMF's.
It might be invisible to the naked eye, but electric and magnetic fields (EMFs), including electromagnetic radiation, are everywhere these days, and chances are it’s taking a major toll on your health. High-tech devices including your mobile phone, laptop, tablet, and wearable tech like the Apple Watch® all generate a near-continuous source of unseen pollution that can be stressful and toxic to your cells. If your goal is to be as healthy as possible, it’s important to address the issues that cell phone radiation and other technology create.
There is only one legitimate method of measuring cell phone radiation recognized by every major health authority and government in the world as well as by the cell phone industry itself, referred to as "SAR". SAR testing measures the "Specific Absorption Rate" of radiation at multiple depths and locations on the head and body in order to quantify how much radiation is actually penetrating it with and without certain safety devices. You can see a SAR test of the R2L device by watching the video below.
The guidelines recommend keeping phones away from the body when they’re not in use—in a backpack, for example, rather than a pocket—and sleeping with phones away from the bed. People may also choose to use speakerphone or a headset to make calls, rather than holding the phone to their heads. (They should remove their headsets when they’re not in use, though, as these devices also emit small amounts of RF frequency.)
The only sure way is to stop using a cell phone. Most people however would prefer to play safe by simply reducing their exposure to radio frequency radiation. Bluetooth devices emit only 10% of the radiation of a cell phone. A hands-free set enables the user to keep the phone away from the head but usually leaves the phone near some other part of the body. It is safe to say that in the event that radio frequency radiation causes damage, you would like to protect other parts of your body. Therefore the only way to reduce your risk is to reduce the radio frequency radiation your body absorbs. SAR Shield reduces radio frequency radiation by up to 89%. 

I love these radiation protection cases. It's a great size for my iphone, and I can even talk on the phone with the phone inside the pouch - perfect sound quality. The only thing I would recommend is that a snap be added to the opening -- it is slippery material. You can tell the company took care in producing a quality product -- it is constructed very well. I recommend this product to cell phone users! Oh, I also got this so quickly!! It arrived within 2-3 days of ordering, and it comes from the UK!! Amazing service!!

Another way to think about the situation is to consider the steady state power emission of .02 Watts and ask how long it would take to heat up your body by one degree Celsius if your entire volume was exposed. Take your body mass to be 100 kg and approximate it as being composed entirely of entirely of water. If all of the radiation was absorbed and went into heating you up (which it isn’t), it would take 20900000 seconds (specific heat*mass*1 degree/power) or 241 days to heat you up by one degree. Fortunately, you have metabolic processes in your body, or possibly air conditioning, to mitigate this heating.
The frequency of radiofrequency electromagnetic radiation ranges from 30 kilohertz (30 kHz, or 30,000 Hz) to 300 gigahertz (300 GHz, or 300 billion Hz). Electromagnetic fields in the radiofrequency range are used for telecommunications applications, including cell phones, televisions, and radio transmissions. The human body absorbs energy from devices that emit radiofrequency electromagnetic radiation. The dose of the absorbed energy is estimated using a measure called the specific absorption rate (SAR), which is expressed in watts per kilogram of body weight.
×